If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
A7N8X-Deluxe Rev 2.0 Raid Boot Question
I have a A7N8X Deluxe board rev 2.0. I am trying to boot off of the raid
controller and I can not get the steeings correct. I have 2 - 120 G drives in raid 0, a Plextor DVD burner on the primary EIDE set as a master, On the secondary EIDE I have a Plextor CDRW set as master and a Lite-On DVD ROM set as a slave. The proble I have is I want to add another 80 G hard drive on my Primary EIDE as a slave for data back up. When I start my system up it will not book because it sees the new 80 G drive and no operationg system. I have tried changing the setting from SCSI to HD0. HD1, HD2, and HD3. I have also disabled all drives in the advanced section for boot up with only boot other devices enabled again no luck. I am using the Uber bios version 1007. Without any drive on the secondary posrt of the primary EIDE I have my boot sequence set to HD0 and it boots fine from the Raid controller, as soon as I add the new drive it screws up. Any help would be appreciated. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
P4C800-E Deluxe and S-ATA RAID... Intel RAID or Promise RAID ??? | Fraizer | Asus Motherboards | 3 | October 29th 03 01:50 PM |
Boot Up Msg- A7N8X Deluxe | Warren | Asus Motherboards | 2 | October 19th 03 11:27 PM |
A7N8X Deluxe Won't Boot from Hard Drives | Dennis | Asus Motherboards | 5 | July 29th 03 07:19 PM |
A7N8X Deluxe SATA boot issue | WDG | Asus Motherboards | 3 | July 26th 03 12:41 AM |
P4C800 Deluxe Raid Controller Question | Vincent Poy | Asus Motherboards | 1 | July 24th 03 12:31 AM |