If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Abit NF7-S and a single RAM module - which slot?
Those of you who are using the NF7-S with a single DIMM. which slot are you
putting it in? 3 does noo work on mine, even though it suggests that in the manual. THanks |
#2
|
|||
|
|||
"Mind Control" wrote
Those of you who are using the NF7-S with a single DIMM. which slot are you putting it in? 3 does noo work on mine, even though it suggests that in the manual. Hi, I heard it was better to use the DIMM slot nearest the CPU, is that slot3? -- Wayne ][ |
#3
|
|||
|
|||
Hi,
I heard it was better to use the DIMM slot nearest the CPU, is that slot3? -- Wayne ][ Nope. Slot 3 is the furthest away from the CPU. I have a single 512Mb Adata module in that slot and the computer works fine. |
#4
|
|||
|
|||
hi,
not sure if the NF7-S is dual channel board but if it is then slot 3 is generally intended to be used for dual channel ddr at least on my soltek board it is. On Wed, 7 Jan 2004 18:44:49 -0500, "Mind Control" wrote: :Those of you who are using the NF7-S with a single DIMM. which slot are you :putting it in? : :3 does noo work on mine, even though it suggests that in the manual. : :THanks : ----- Lee. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Expert advise on RAM problem needed | Mattrixx | General | 6 | February 6th 05 09:19 PM |
On the brink of madness... | I.C. Koets | General | 18 | January 31st 05 10:49 PM |
Updrade PC | Guy Smith | General | 22 | August 15th 04 01:57 AM |
Fastfame 370SPC slotket - 370 to slot adapter help needed! | Ixnei | Overclocking | 1 | February 4th 04 12:40 AM |
FIC or HIS for a 9600Pro? | Phrederick | General | 8 | December 16th 03 12:17 PM |