If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
GA-8KNXP and Zalman CNPS 7000 cooler question
Hi,
Just about to purchase the above two items, saw the thread earlier about fitting etc. Do you use the fan speed controller? or just have it running full speed? My case an Antec Quiet, has a fan connector from the power supply that is speed regulated, which I could connect to the Zalman, which would then be speed varied according to the temp sensor in the power supply area. Not sure if thats a good idea. Is the Zalman noisy(ish) when on full speed. thanks al |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
8KNXP and Zalman CNPS7000A-Cu CPU Cooler | Tim | Gigabyte Motherboards | 1 | September 8th 03 09:03 PM |
8KNXP and Zalman CNPS7000-Cu | Bob Davis | Gigabyte Motherboards | 5 | July 26th 03 04:03 PM |