If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
OClock newbie needs help DS3 rev 3.3
E4300
Mushkin 800 DDR2 stix stock voltages OK I've got it running at~ FSB 350 DRAM 525 cpuid = 2:3 cpuid further shows: Rated FSB = 1400 (which is FSB 350 x 4, which means what??) I'm really not sure if any of this is good or should be better? Is the memory being underclocked unnecessarily? is 2:3 poor? where stock = 1:2, does that mean the memory is really running at 600? (1:2 = 800) Bob |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
newbie o/c amd | stevej | Overclocking AMD Processors | 14 | April 25th 05 09:14 AM |
K8N newbie | DeRanger | Asus Motherboards | 4 | April 20th 05 10:39 PM |
Newbie Help | andre259 | Cdr | 5 | June 7th 04 06:45 PM |
Newbie needs help. | Jim Kelley | General | 11 | April 21st 04 04:15 AM |
Newbie | bar bar blaksheep | Cdr | 4 | September 13th 03 11:23 PM |