If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
52.16 (tv-out) overlay clone mode not working
Hi all, in my GF4 4200Ti when I select (in nview) "clone" display mode, and
then set "full screen overlay video device" to my secondary screen (TV) I get a flickering white image. Even the refresh rate is the default (60Hz), it should be this for TV, and my previous driver 45.23 do it 100% ok. I tried dozens of alternative configs but with no success. And more irritating is when I do not select any fullscreen device for overlay... the card can't do overlay in the desktop. I remember that this happened many times in other "beta" drivers 4x.xx, but never in final releases. Any "repro" over there?. Greets, [s]arrow. |
#2
|
|||
|
|||
"[s]arrow" wrote in message ...
Hi all, in my GF4 4200Ti when I select (in nview) "clone" display mode, and then set "full screen overlay video device" to my secondary screen (TV) I get a flickering white image. Even the refresh rate is the default (60Hz), it should be this for TV, and my previous driver 45.23 do it 100% ok. I tried dozens of alternative configs but with no success. And more irritating is when I do not select any fullscreen device for overlay... the card can't do overlay in the desktop. I remember that this happened many times in other "beta" drivers 4x.xx, but never in final releases. Any "repro" over there?. Greets, [s]arrow. I have exactly the same problem. If, however, you use an analogue monitor and a digital monitor (with either as the primary), overlays work fine on the primary or secondary device. Changing the TV between primary and secondary doesn't change anything, but if you try to put the other device (the monitor) as the fullscreen device, that works fine... I think I'm going to have to go back to 45.23, for the time being... STeve |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Are AMD Athlon 64 Socket 939 processors with 4 double sided DDR400 modules in dual channel mode limited to DDR333? | Glzmo | Overclocking AMD Processors | 1 | October 4th 04 10:17 AM |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
Protected vs Real | esara | Homebuilt PC's | 1 | May 1st 04 06:00 AM |
ND-1300A not supporting burning CDs in DMA mode | Ville Portti | Cdr | 0 | April 15th 04 02:17 PM |
Power Surge | David LeBrun | General | 44 | September 12th 03 02:35 AM |