If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hum in speakers SB Live Platinum (not 5.1)
Trying to connect my Live to my stereo system (Harmon-Kardon amp -
good quality), I always get a HUMMMM. The sound goes through but I have to listen to that hum. Using the headphone sound is clear. I have updated driver. Am using 1/8 inch outlet to the two 1/4 in (name???) connectors on amplifier. When I use this setup with a small stereo system I don't get the hum. I am really confused. Thanks in advance. Gil |
#2
|
|||
|
|||
Trying to connect my Live to my stereo system (Harmon-Kardon amp - good quality), I always get a HUMMMM. HUMMMMs are often indicative of a grounding problem - or possibly lack of the same, or bad cables/connectors. Make sure your sound system and your PC are both attached to the same GROUNDED power outlet. Also make sure you have decent quality shielded cables, and that they don't run parallel to power cables and such, as this can in some (in my experience rare, but better safe than sorry) cases cause interference through induction. I assume other sound sources attached to the same inputs on your amplifier do not hum as well? If you haven't done this, do that also, just to rule out your amp having a busted set of inputs. I have updated driver. For once, this is not a driver issue! |
#3
|
|||
|
|||
It is a good idea that it may be ground related. I went and plugged
the computer in the same power bar as the amplifier... and continued to get the same hum. But you must be right. When I hold the connector in my hand and touch it I start a small hum, just from my body's magnetism ! ! ! Could the power bar not be grounded? How could I test all that? Guess I need an electrician-electronician. Gil On Wed, 20 Oct 2004 22:15:18 GMT, "Lenny" wrote: Trying to connect my Live to my stereo system (Harmon-Kardon amp - good quality), I always get a HUMMMM. HUMMMMs are often indicative of a grounding problem - or possibly lack of the same, or bad cables/connectors. Make sure your sound system and your PC are both attached to the same GROUNDED power outlet. Also make sure you have decent quality shielded cables, and that they don't run parallel to power cables and such, as this can in some (in my experience rare, but better safe than sorry) cases cause interference through induction. I assume other sound sources attached to the same inputs on your amplifier do not hum as well? If you haven't done this, do that also, just to rule out your amp having a busted set of inputs. I have updated driver. For once, this is not a driver issue! |
#4
|
|||
|
|||
I found the problem. It was likely ground related. I found out that
the problem was with the cable that was connected to the amplifier to use FM stations. It works now well with computer OR cable but not both together. That's OK with me. Gil On Wed, 20 Oct 2004 14:06:22 -0400, gilles wrote: Trying to connect my Live to my stereo system (Harmon-Kardon amp - good quality), I always get a HUMMMM. The sound goes through but I have to listen to that hum. Using the headphone sound is clear. I have updated driver. Am using 1/8 inch outlet to the two 1/4 in (name???) connectors on amplifier. When I use this setup with a small stereo system I don't get the hum. I am really confused. Thanks in advance. Gil |
#5
|
|||
|
|||
Yes a ground problem, get a yard of turf and a piece of copper wire and run
the copper wire from your computer to the turf. If this does not work, try turning the line in, or other sliders bars down until until the hiss goes. click on the speaker icon and adjust all sliders, I suspect you will have to go to options in volume control, properties, record, and see what channel is causing the hiss. wrote in message ... I found the problem. It was likely ground related. I found out that the problem was with the cable that was connected to the amplifier to use FM stations. It works now well with computer OR cable but not both together. That's OK with me. Gil On Wed, 20 Oct 2004 14:06:22 -0400, gilles wrote: Trying to connect my Live to my stereo system (Harmon-Kardon amp - good quality), I always get a HUMMMM. The sound goes through but I have to listen to that hum. Using the headphone sound is clear. I have updated driver. Am using 1/8 inch outlet to the two 1/4 in (name???) connectors on amplifier. When I use this setup with a small stereo system I don't get the hum. I am really confused. Thanks in advance. Gil --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.799 / Virus Database: 543 - Release Date: 19/11/2004 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Speakers problems with my Live Player on WinXP | Lima | Creative Sound Blaster Cards | 1 | October 9th 04 12:42 PM |
SoundBlaster Live! 5.1 & Stereo Speakers | Surendra | Creative Sound Blaster Cards | 1 | October 9th 04 05:56 AM |
Creative lies about Sound Blaster Live! Platinum [previous pt5] | P Moyst | Creative Sound Blaster Cards | 0 | May 4th 04 03:39 PM |
Clean XP - SB Live Platinum 5.1 Install | Steve Young | Creative Sound Blaster Cards | 2 | April 18th 04 05:01 PM |
Live Platinum (not 5.1) XP and Cubasis | Eddie Bromhead | Creative Sound Blaster Cards | 1 | July 5th 03 07:16 PM |