|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 29th 03, 03:24 PM
|
|||
|
|||
This copy protected disc can not be played when the TV out function is enabled.
On Sun, 29 Jun 2003 14:33:21 +0100 the meepish "orlimar"
meeped : How do I disable the TV out function? The card is a GeForce 2MX-400, drivers Version 41.09 on WindowsXP. TIA get TVTool.. it removes macrovision protection. it's vert cheap and actually worth the money. http://tvtool.info/index_e.htm -- "please excuse me from gym...I've got this terrible cold coming on.." 
|
|
#2
June 29th 03, 04:50 PM
|
|||
|
|||
|
Went and got TVTool
Now, what do I do with it? Followed all the prompts, lost my monitor a couple of times & the message comes back all the time - This copy protected disc can not be played when the TV out function is enabled.
|
|
#3
June 29th 03, 05:47 PM
|
|||
|
|||
|
On Sun, 29 Jun 2003 16:50:04 +0100 the meepish "orlimar"
meeped : Went and got TVTool Now, what do I do with it? Followed all the prompts, lost my monitor a couple of times & the = message comes back all the time -=20 This copy protected disc can not be played when the TV out function is = enabled. did you "tick" the box that says [ Macro Off ] it's on the [MODE] tab. -- "please excuse me from gym...I've got this terrible cold coming on.."
|
|
#4
June 30th 03, 04:58 AM
|
|||
|
|||
|
"Granulated" wrote in message ... On Sun, 29 Jun 2003 16:50:04 +0100 the meepish "orlimar" meeped : Went and got TVTool Now, what do I do with it? Followed all the prompts, lost my monitor a couple of times & the = message comes back all the time -=20 This copy protected disc can not be played when the TV out function is = enabled. did you "tick" the box that says [ Macro Off ] it's on the [MODE] tab. -- "please excuse me from gym...I've got this terrible cold coming on.." Or you could roll back to an older version of the driver. Running the 41.09's isin't going to help a Geforce 2 all that much. Use the 30.82's and you'll be in like Flynn.
|
|
#5
June 30th 03, 10:51 AM
|
|||
|
|||
|
Installed some drivers that came with the board - 2.3 dated 29/11/2001
Moulin Rouge now playing like a dream using Power DVD. Thanks for the advice. Would like to know why later drivers are detrimental though.
|
|
#6
June 30th 03, 04:33 PM
|
|||
|
|||
|
apparently i hear this app overcomes this issue
i havent tried it so dont know remote selector http://eximius.nl/rs/ ceedee "orlimar" wrote in message ... Installed some drivers that came with the board - 2.3 dated 29/11/2001 Moulin Rouge now playing like a dream using Power DVD. Thanks for the advice. Would like to know why later drivers are detrimental though.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mustek 1200 III EP undetectable in any image program | Raymond A. Chamberlin | Scanners | 18 | January 10th 05 08:52 AM |
| writing cd`s | biggmark | Cdr | 7 | December 31st 04 08:57 AM |
| Advice Please: The Importance of Hard Drive RPMs | Darren Harris | Homebuilt PC's | 95 | August 24th 04 11:16 PM |
| When Good Discs Go Bad | Ablang | General | 0 | June 27th 04 03:47 AM |
| Can't copy Microsoft CDs but I've done it before with Plex and ECDC?Using Liteon and Nero | smh | Cdr | 15 | December 8th 03 11:24 PM |
Linear Mode
