If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Gateway RQ5 Docking Station - Serial Port (RS232) doesn't work
I got a docking station for my Gateway M465e because the power input
doesn't function (I purchased it used betting that I could fix it). And I figure the easy fix would be getting a docking station. And then get power through it. A gamble I guess, but it worked. grin I really don't think the docking station has its own charging circuit or anything. And if this is correct, it should be either the jack is bad or a run somewhere on the motherboard to get that to work again, you think? I also don't like to leave batteries in my laptops. Only when they are in use or charging. Sadly, the trigger to lock the laptop in the docking station presses on the battery. Without it, no lock. So I cut a piece of wood in my work shop the same size and shape of the battery. And slid it in and that works wonderfully. ;-) Oddly enough, I can't get the serial port of the docking station to work with my Palm IIIc. I tried with Windows XP Pro and Windows 7 RC and no go. The Device Manager shows all is well. Used a serial to USB adapter and it works that way. Although it would be nice if the serial port worked too. I don't see any drivers you need to make it work. There isn't any, is there? I have no idea if the parallel port works, but everything else does. Also supposedly you can remove the laptop from the docking port while it is running. Yes that works, although the release gives a huge kick. My event log shows bad sectors on the hard drive whenever I do that. So I don't think that is a good idea to do. I was also surprised to learn that if you remove power from the docking station, the laptop battery powers both. As the docking station requires a lot more power than just the laptop alone (120 watts vs 65 watts). And I didn't see a big drain on the battery in this state. Interesting, no? -- Bill Gateway MX6124 ('06 era) 2 of 3 - Windows XP SP3 |
#2
|
|||
|
|||
Gateway RQ5 Docking Station - Serial Port (RS232) doesn't work
BillW50 wrote:
I got a docking station for my Gateway M465e because the power input doesn't function (I purchased it used betting that I could fix it). And I figure the easy fix would be getting a docking station. And then get power through it. A gamble I guess, but it worked. grin I really don't think the docking station has its own charging circuit or anything. And if this is correct, it should be either the jack is bad or a run somewhere on the motherboard to get that to work again, you think? I also don't like to leave batteries in my laptops. Only when they are in use or charging. Sadly, the trigger to lock the laptop in the docking station presses on the battery. Without it, no lock. So I cut a piece of wood in my work shop the same size and shape of the battery. And slid it in and that works wonderfully. ;-) Oddly enough, I can't get the serial port of the docking station to work with my Palm IIIc. I tried with Windows XP Pro and Windows 7 RC and no go. The Device Manager shows all is well. Used a serial to USB adapter and it works that way. Although it would be nice if the serial port worked too. I don't see any drivers you need to make it work. There isn't any, is there? I have no idea if the parallel port works, but everything else does. Also supposedly you can remove the laptop from the docking port while it is running. Yes that works, although the release gives a huge kick. My event log shows bad sectors on the hard drive whenever I do that. So I don't think that is a good idea to do. I was also surprised to learn that if you remove power from the docking station, the laptop battery powers both. As the docking station requires a lot more power than just the laptop alone (120 watts vs 65 watts). And I didn't see a big drain on the battery in this state. Interesting, no? The port might be disabled in the bios?? Or in a non-standard bios state? That is certainly possible for the parallel port, I am not sure about your serial port. |
#3
|
|||
|
|||
Gateway RQ5 Docking Station - Serial Port (RS232) doesn't work
In ,
Sjouke Burry typed on Mon, 11 Jan 2010 05:42:39 +0100: The port might be disabled in the bios?? Or in a non-standard bios state? That is certainly possible for the parallel port, I am not sure about your serial port. Thanks Sjouke! I was in there before and everything looked good. And I just fired it up again and double checked. There are three settings: Off, On, and Auto. The latter lets the BIOS and OS adjust the settings. Basically Plug and Play. The On setting allows you manual control of the serial port. It is currently set to auto. The serial and parallel ports are there on or off of the docking station. Although there is no serial or parallel ports on the laptop itself. There are two ways of doing this. One that the ports are real and are wired to the docking port. Or they do it through the USB. Although drivers should be required for the latter, I would think. I would think the former since the BIOS knows about it even without the docking station. -- Bill Gateway M465e ('06 era) - Windows XP SP3 |
#4
|
|||
|
|||
Gateway RQ5 Docking Station - Serial Port (RS232) doesn't work
BillW50 wrote:
In , Sjouke Burry typed on Mon, 11 Jan 2010 05:42:39 +0100: The port might be disabled in the bios?? Or in a non-standard bios state? That is certainly possible for the parallel port, I am not sure about your serial port. Thanks Sjouke! I was in there before and everything looked good. And I just fired it up again and double checked. There are three settings: Off, On, and Auto. The latter lets the BIOS and OS adjust the settings. Basically Plug and Play. The On setting allows you manual control of the serial port. It is currently set to auto. The serial and parallel ports are there on or off of the docking station. Although there is no serial or parallel ports on the laptop itself. There are two ways of doing this. One that the ports are real and are wired to the docking port. Or they do it through the USB. Although drivers should be required for the latter, I would think. I would think the former since the BIOS knows about it even without the docking station. I dont know much about docking stations, but I expect the laptop bios in the auto mode to disable them when outside the docking station. If you are not using shutdown, but sleep instead, I would expect the laptop not to enable the ports, when you plug it back in. Personally I would use the "On" setting in the bios, and the "standard" option when available, but I dont know your bios well enough. |
#5
|
|||
|
|||
Gateway RQ5 Docking Station - Serial Port (RS232) doesn't work
BillW50 wrote:
In , Sjouke Burry typed on Mon, 11 Jan 2010 05:42:39 +0100: The port might be disabled in the bios?? Or in a non-standard bios state? That is certainly possible for the parallel port, I am not sure about your serial port. Thanks Sjouke! I was in there before and everything looked good. And I just fired it up again and double checked. There are three settings: Off, On, and Auto. The latter lets the BIOS and OS adjust the settings. Basically Plug and Play. The On setting allows you manual control of the serial port. It is currently set to auto. The serial and parallel ports are there on or off of the docking station. Although there is no serial or parallel ports on the laptop itself. There are two ways of doing this. One that the ports are real and are wired to the docking port. Or they do it through the USB. Although drivers should be required for the latter, I would think. I would think the former since the BIOS knows about it even without the docking station. Oh, and btw, the physical ports I think ARE on the laptop, it is just that the connectors are on the docking station, with the wiring coming from the multipin docking connector. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Optiplex 755 serial port - cannot get it to work | Bigguy[_3_] | Dell Computers | 8 | May 1st 09 04:19 PM |
1K572 (P/N) Port Replicator/Docking Station? | Conan Kelly | Dell Computers | 7 | October 18th 06 08:58 PM |
Modify Dell Inspiron Laptop 2 work w C/Dock Docking Station | JLA | Dell Computers | 7 | September 21st 05 11:50 PM |
Modify Dell Inspiron Laptop 2 work w C/Dock Docking Station | JLA | Dell Computers | 0 | September 21st 05 02:06 AM |
Will 9453U Docking Station work with Latitude CPiA400? | mike | Dell Computers | 0 | May 30th 04 07:20 AM |