If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
P4 XEON Heatsink Retention Clip Tool
Am i am trippin or isn't there a tool for those damn clips?
|
#2
|
|||
|
|||
On Mon, 05 Jul 2004 22:24:16 GMT, e wrote:
Am i am trippin or isn't there a tool for those damn clips? Um, there should be a mess of lil plastic bits that form a nasty little puzzle box around the heatsink/fan/processor and then the whole thing is held to the board by these lil white plastic pins. -- Onideus Mad Hatter mhm ¹ x ¹ http://www.backwater-productions.net |
#3
|
|||
|
|||
On Mon, 05 Jul 2004 22:24:16 GMT, e wrote:
Am i am trippin or isn't there a tool for those damn clips? Needle-noise pliers, a flat screwdriver, chisel, punch, saw, wood glue, 25 yd. of string, weaving loom and a 10 lb. hammer. |
#4
|
|||
|
|||
LOL Thats what I have been using with the exception that I use grease on
the flat head for an element of danger. But I thought Intel had a nifty tool just for these things. Oh well. kony wrote in news:h0vke0pu3krmn3r2a1v7fh7dto4r7sjrbr@ 4ax.com: On Mon, 05 Jul 2004 22:24:16 GMT, e wrote: Am i am trippin or isn't there a tool for those damn clips? Needle-noise pliers, a flat screwdriver, chisel, punch, saw, wood glue, 25 yd. of string, weaving loom and a 10 lb. hammer. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Faulty fans: dust or bearings? | S.Boardman | General | 37 | October 16th 03 10:34 AM |
Thermal pad or Thermal paste? | Vin | General | 68 | September 17th 03 05:38 AM |
Cooling Questions | Peter Cavan | General | 35 | September 2nd 03 06:42 AM |