If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
P4P800 Deluxe, No Post, No Fans
I reseated the P4 3.06 after receiving "System Failed CPU test" at boot.
Now my P4P800 Deluxe shows no signs of life. No fans or no POST. The mobo is receiving power due to the green light on mobo. I know it is something simple but i have yet to figure it out. MY hardwa ASUS P4P800 Deluxe, ATI Radeon 9800 Pro 128Mb, Onboard sound and NIC, Enermax 550 Watt PSU, Samsung 352 Combo drive, Pioneer DVD-RW A04, Maxtor 160Gb Hard Drive 8Mb Cache, Sony Floppy Drive and 2xCrucial DDR-3200 RAM. Thanks NBK |
#2
|
|||
|
|||
I had this problem with my new P4P800se, caused by my new wireless keyboard!
I had to press re-set everytime to kick it into action. Is your K/B connected properly (it may not boot without it) or, like me, have you got it connected via USB AND PS2 (I know, Im stupid!) Just a thought? Nik. "NBK" wrote in message om... I reseated the P4 3.06 after receiving "System Failed CPU test" at boot. Now my P4P800 Deluxe shows no signs of life. No fans or no POST. The mobo is receiving power due to the green light on mobo. I know it is something simple but i have yet to figure it out. MY hardwa ASUS P4P800 Deluxe, ATI Radeon 9800 Pro 128Mb, Onboard sound and NIC, Enermax 550 Watt PSU, Samsung 352 Combo drive, Pioneer DVD-RW A04, Maxtor 160Gb Hard Drive 8Mb Cache, Sony Floppy Drive and 2xCrucial DDR-3200 RAM. Thanks NBK |
#3
|
|||
|
|||
In article , NBK
wrote: I reseated the P4 3.06 after receiving "System Failed CPU test" at boot. Now my P4P800 Deluxe shows no signs of life. No fans or no POST. The mobo is receiving power due to the green light on mobo. I know it is something simple but i have yet to figure it out. MY hardwa ASUS P4P800 Deluxe, ATI Radeon 9800 Pro 128Mb, Onboard sound and NIC, Enermax 550 Watt PSU, Samsung 352 Combo drive, Pioneer DVD-RW A04, Maxtor 160Gb Hard Drive 8Mb Cache, Sony Floppy Drive and 2xCrucial DDR-3200 RAM. Thanks NBK First, remove the video card (with power off and power cord unplugged before doing the deed). Try to power up the system. It could be that the Agp_Warn circuit is stopping the motherboard from powering up, and without the video card, the fans should start when you press the button. Power off and unplug again. Plug the video card back in, connecting its aux power cable to the PS (and no other loads on that cable - leave the leftover 4 pin connector unused). Make sure the video card is well seated. The gold fingers shouldn't be visible if the card is pushed all the way into the AGP socket. Sometimes, you have to loosen all PCI card screws and motherboard screws and move the motherboard a bit, to ease the alignment between the inserted cards and the motherboard. I like to do that with one PCI and one AGP card installed, and adjust the position until the cards can be removed or inserted without stress. When doing this, check the metal screw heads on the standoffs, to make sure they aren't touching any conductors or components next to the mounting holes, as some cases use screws with large screw heads on them. Also make sure you are using the standoffs that came with the case (they aren't interchangeable between computer cases) and _no_ washers on the standoffs. See it it starts. If none of that is working, try unplugging the CPU again. Verify you didn't rotate it 90 degrees and crush some pins (easy to do). Great damage could result from an accident like that. Like new CPU and new motherboard. You can use the Voice POST and listen for error messages. Make sure the two jumpers are put back on the FP_AUDIO header, then connect amplified speakers to the Lineout (lime colored) jack on the back of the computer. I've just started building up a board, by adding one component at a time, and I notice you have to wait a significant time (a minute or two) for some of the error messages to show up. Voice POST, for example, can even tell you the processor is missing. Some error messages are delivered almost immediately, while others take some time for the BIOS to get to them. HTH, Paul |
#4
|
|||
|
|||
Paul wrote:
In article , NBK wrote: I reseated the P4 3.06 after receiving "System Failed CPU test" at boot. Now my P4P800 Deluxe shows no signs of life. No fans or no POST. The mobo is receiving power due to the green light on mobo. I know it is something simple but i have yet to figure it out. MY hardwa ASUS P4P800 Deluxe, ATI Radeon 9800 Pro 128Mb, Onboard sound and NIC, Enermax 550 Watt PSU, Samsung 352 Combo drive, Pioneer DVD-RW A04, Maxtor 160Gb Hard Drive 8Mb Cache, Sony Floppy Drive and 2xCrucial DDR-3200 RAM. Thanks NBK First, remove the video card (with power off and power cord unplugged before doing the deed). Try to power up the system. It could be that the Agp_Warn circuit is stopping the motherboard from powering up, and without the video card, the fans should start when you press the button. Power off and unplug again. Plug the video card back in, connecting its aux power cable to the PS (and no other loads on that cable - leave the leftover 4 pin connector unused). Make sure the video card is well seated. The gold fingers shouldn't be visible if the card is pushed all the way into the AGP socket. Sometimes, you have to loosen all PCI card screws and motherboard screws and move the motherboard a bit, to ease the alignment between the inserted cards and the motherboard. I like to do that with one PCI and one AGP card installed, and adjust the position until the cards can be removed or inserted without stress. When doing this, check the metal screw heads on the standoffs, to make sure they aren't touching any conductors or components next to the mounting holes, as some cases use screws with large screw heads on them. Also make sure you are using the standoffs that came with the case (they aren't interchangeable between computer cases) and _no_ washers on the standoffs. See it it starts. If none of that is working, try unplugging the CPU again. Verify you didn't rotate it 90 degrees and crush some pins (easy to do). Great damage could result from an accident like that. Like new CPU and new motherboard. You can use the Voice POST and listen for error messages. Make sure the two jumpers are put back on the FP_AUDIO header, then connect amplified speakers to the Lineout (lime colored) jack on the back of the computer. I've just started building up a board, by adding one component at a time, and I notice you have to wait a significant time (a minute or two) for some of the error messages to show up. Voice POST, for example, can even tell you the processor is missing. Some error messages are delivered almost immediately, while others take some time for the BIOS to get to them. HTH, Paul I have decided to RMA the mobo after trying a few things. NBK |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A7N8X Deluxe: Rock sold for months, yet occasional vocal "memory test failed" at POST...memtest86 3.0 finds nothing.. | John Q. Public | Asus Motherboards | 6 | December 1st 03 04:54 PM |
Memory for the P4P800 Deluxe | Linux Lover | Asus Motherboards | 10 | November 18th 03 01:45 AM |
hard disks settings on P4P800 DeLuxe | Ledan | Asus Motherboards | 2 | November 5th 03 03:12 PM |
P4P800 Deluxe - Disk read error occured - Help! | Jim | Asus Motherboards | 2 | October 23rd 03 03:09 PM |
p4p800 Deluxe: Should I get Kingston Value RAM or Hyper X DDR? | Steve | Asus Motherboards | 1 | August 5th 03 11:59 PM |