If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Adding USB 2.0
Has anyone here had any problems adding a USB 2.0 card to a system USB 1.0
system? Would you have to disable 1.0 before adding the 2.0 card, or just add the card, load the software and connect? Thanks, -- Curt. |
#2
|
|||
|
|||
"Curt" Ran in the back door and shouted
.com: Has anyone here had any problems adding a USB 2.0 card to a system USB 1.0 system? Would you have to disable 1.0 before adding the 2.0 card, or just add the card, load the software and connect? Thanks, Add the card, load software & connect. Your PC's USB ports will still fuction as usb 1.1, the card will be the only usb 2.0 ports. -- MrToad |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Adding a Hard Drive | Eric Scofield | General | 5 | November 4th 03 06:01 AM |
Problem booting up after adding new hardware | Slaphead | General | 4 | October 17th 03 10:49 PM |
adding a PS2 port to an old PC | Jan Biel | General | 6 | September 30th 03 03:13 PM |
Adding CDR-W - - - System Hangs | Robert Spike | General | 4 | September 26th 03 03:15 AM |
Adding ATA 133 Controller Card | Michael L. Coleman | General | 4 | September 21st 03 07:20 AM |