If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cold-Boot problems with Powercolor 9800 Pro graphic card
Hi!
I need a few more ideas because of a strange phenomena I have with a Powercolor 9800 Pro graphic card: When I turn on the PC for the first time a day, the card does not seem to initialize correctly resulting in a totally messed up output with no readable content. When I power down the PC and then turn it on again: the same. After disconnecting the PC from the power supply, wait 10 seconds and try it again, then it suddenly works. I even got the same strange behaviour during installation of the card: Put it in and connected all cables back to the PC - nothing; installed old card and then again the Powercolor without every cable - works; then connected everything - works not etc. But when I put the card in an older PC, it works at the first try. But back to my PC, nothing again?!?!? But when the card is running, there are no more problems - at least for that day. Any hint would be appreciated! Thanks! Stefan |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Compaq Plus Luggable boot problems | Casey Tompkins | General | 3 | February 21st 04 11:44 AM |
Boot problems after new hardware! | Timothy Lister | General | 5 | September 29th 03 08:19 PM |
WinXP Boot problems *sigh* | Martin | General | 2 | August 30th 03 03:01 AM |
WinXP Boot problems *sigh* - UPDATE - Help? | Phrederik | General | 0 | August 29th 03 04:41 PM |
Boot Problems | Cuzman | General | 1 | August 19th 03 10:12 PM |