If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Timeout Failure during SCSI Inquiry Command
Greetings all!
I am going crazy trying to figure out an issue with the following hardwa * Windows 2000 Server SP4 (Intel-based) * DEC DLT 7000 Drive Fast-Wide, HVD (High Voltage Differential) with SCSI-2 Internal Connector * Adaptec AHA-2944UW HVD SCSI controller * Internal 68pin high-density LVD cable - Terminated single-ended SCSI cable with three high density 68 pin (M) connectors - 0.9m (2.8ft) long When I go to boot the server I get the following error message from the Adaptec SCSI controller card: "Timeout Failure during SCSI Inquiry Command!" I've cheked all of the connections, made sure the SCSI ID's are set correctly, tried disabling parity on the controller and drive, tried disabling termination on the drive and only using the cable end terminator, and the other connectors on the cable. Does anyone have any thoughts? Thanks in advance for your assistance, Steven |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
15K rpm SCSI-disk | Ronny Mandal | General | 26 | December 8th 04 08:04 PM |
Newbie Question re hardware vs software RAID | Gilgamesh | General | 44 | November 22nd 04 10:52 PM |
Raptor or SCSI - Which is going to perform the best? | Marc Brown | General | 37 | September 30th 04 12:46 AM |
Timeout Failure during SCSI Inquiry Command | Anotherhick | General | 1 | February 15th 04 02:51 PM |
SCSI trouble | Alien Zord | General | 1 | June 25th 03 03:08 AM |