If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
p4 overclocking error
Well, i just installed a water-cooling system to start overclocking -
fooled around with the fsb speed in bios and rebooted the computer. Everything goes well until the computer tries to load windows. I get an error saying "Windows could not start because of an error in the software Please report this problem as: load needed DLLs for kernel. Please contact your support person to report this problem." I know is not a problem from tryin to increase the fsb too much cuz I tried from 133.3 x 17(original speed) to 133.6 x 17 and i still get the same error msg. Do i need to do something in the registry or what? |
#2
|
|||
|
|||
Did you overclock your pci bus? It should only run at 33Mhz. Anything over
33 will give you unwanted OS errors. "-=adrenaline" wrote in message om... Well, i just installed a water-cooling system to start overclocking - fooled around with the fsb speed in bios and rebooted the computer. Everything goes well until the computer tries to load windows. I get an error saying "Windows could not start because of an error in the software Please report this problem as: load needed DLLs for kernel. Please contact your support person to report this problem." I know is not a problem from tryin to increase the fsb too much cuz I tried from 133.3 x 17(original speed) to 133.6 x 17 and i still get the same error msg. Do i need to do something in the registry or what? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A7N8X Motherboard Low Temperature Sensitivity, CMOS Checksum Error | kony | General | 6 | October 18th 04 05:38 AM |
CRC error in DVD burner signal | Larc | General | 0 | August 18th 04 04:01 AM |
FIC or HIS for a 9600Pro? | Phrederick | General | 8 | December 16th 03 12:17 PM |
OverClocking Guides | Phil Weldon | Overclocking | 0 | August 15th 03 05:41 AM |
"unknown hard error" message | Franklin | General | 2 | August 4th 03 10:53 PM |