|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 6th 05, 07:17 AM
|
|||
|
|||
proliant 3000 - the second
Hi,
i test with my Proliant 3000 a lot. But I badly need a floppy disk to configure the Smart Array Controller 3200, cause the SmartStart Cd won't boot and no OS is installed. On the HP Homepage there only disks for Windows, but not vor without windows. Any help? Cheers, coffi 
|
|
#2
May 6th 05, 01:19 PM
|
|||
|
|||
|
you might try downloading the SystemErase diskette and running that. It will
clear out all the NVRAM and clear the disk and array controller configuration as well. Once this is done, you should be able to boot from the CD to run SmartStart to setup the system. - LC "coffi" wrote in message ... Hi, i test with my Proliant 3000 a lot. But I badly need a floppy disk to configure the Smart Array Controller 3200, cause the SmartStart Cd won't boot and no OS is installed. On the HP Homepage there only disks for Windows, but not vor without windows. Any help? Cheers, coffi
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Proliant 3000 Dual processor not recognized | JanN | Compaq Servers | 7 | October 12th 04 06:51 PM |
| 600 MHz P3 in Proliant 3000 (ES1003) | Jes Vestervang | Compaq Computers | 5 | October 8th 04 05:08 AM |
| Proliant 3000 Fans | Matt Fuerst | Compaq Computers | 6 | September 16th 04 02:15 AM |
| I can't configure my disk array in ProLiant 3000 | NuT CrAcKeR | Compaq Servers | 3 | January 12th 04 03:40 AM |
| FS: Qty. 11 Compaq Proliant Systems $1,500 - 3000, 4500, 5500's | 444UNIX | Compaq Computers | 0 | November 3rd 03 02:29 PM |
Linear Mode
