If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ghosting on my monitor
Just wondering if my 19" ADI Microscan is biting the bullet. There are ghost lines running across the screen. Does this mean its dying or could a new, quality shielded cable help?
Thanks Giz |
#2
|
|||
|
|||
Gizzo wrote:
Just wondering if my 19" ADI Microscan is biting the bullet. There are ghost lines running across the screen. Does this mean its dying or could a new, quality shielded cable help? Thanks Giz Generally they go dim first, or lose the ability to guide the guns and produce rainbow/moire effects. Make certain that your cable is shielded properly first, and that you're not running it by any high energy EMF sources (power cables, bad cables, etc). Also make sure the portion where it connects to the monitor is not kinked or yanked around, it can be stressing the wires. Try a different video card (and don't use a passthrough). Lastly, see about getting your monitor professionally degaussed. And by professionally I mean the bub down at the VCR repair shack with a degaussing wand. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DVI Monitor "no signal" with ATI Radeon 9600 Pro | Thomas Bollinger | Ati Videocards | 3 | October 1st 04 12:05 AM |
Is Dell P1110 21" monitor the same as Liyama S102GT 21" monitor? | private person | Homebuilt PC's | 0 | February 25th 04 05:56 PM |
Ghosting and unclear print w/ATI 9200 SE & Cornea 17" LCD monitor combo - help?! | Dr Richard Cranium | Ati Videocards | 7 | January 5th 04 07:19 AM |
G550 no monitor setting for 2 monitors | Leon | Matrox Videocards | 2 | September 15th 03 05:07 PM |
strange monitor phenomenon | Vanguard | General | 0 | July 26th 03 05:21 PM |