If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
p4p800 deluxe temps and voltage readout issues
I don't know if this has been beaten to death... I'm a new owner...
asus probe has the mobo at 25C and the cpu at 22C. MBM has the mobo (or the case) roughly the same as Asus probe and I can't really find a sensor that will give me readings for the CPU that aren't in the 0C, 80C, or 127C range with bells and whistles flashing. What sensor in MBM are folks using? And what's with the Asus probe temp readings? You'd think they'd be correct for being an in-house program BTW, using bios 1010. Voltage wise cpu-z gives me a reading of 1.6-1.61v, asus probe is at 1.56-1.57 and it's set in the Bios at AUTO or 1.52v. any tips? |
#2
|
|||
|
|||
I just put together a p4p800s and i note quite a diffreence in temp readings
from the bios and from Asus probe like 25 C on ASUS probe abd 36 C in the bios. something's amiss here Tom wrote in message ... I don't know if this has been beaten to death... I'm a new owner... asus probe has the mobo at 25C and the cpu at 22C. MBM has the mobo (or the case) roughly the same as Asus probe and I can't really find a sensor that will give me readings for the CPU that aren't in the 0C, 80C, or 127C range with bells and whistles flashing. What sensor in MBM are folks using? And what's with the Asus probe temp readings? You'd think they'd be correct for being an in-house program BTW, using bios 1010. Voltage wise cpu-z gives me a reading of 1.6-1.61v, asus probe is at 1.56-1.57 and it's set in the Bios at AUTO or 1.52v. any tips? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Re Voltage / CPU Temperature on A7N8X Deluxe v2 | McBain | Asus Motherboards | 25 | December 20th 03 10:21 PM |