If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
proliant 500 and duplexing kit
Hi.
I have found some weeks ago a proliant 5000 with dual PPRo200, 128M, 4 disk 2.1 gbytes and a duplexing kit. I'd want to eliminate this kit and return to standard scsi configuration, but removing the board installed on the back of the disk backplane is not sufficient In fact the on board controller recognize and spin up only 2 of 4 disks. What i have to do? Thanks Fabio -- + ------------------------------------------+ + E non proferir mai verbo + + che plauda al vizio o la virtu' derida. + +-------------------------------------------+ + Genesis 1000 and now R6 + +-------------------------------------------+ |
#2
|
|||
|
|||
you have to replace the duplexing board with the orginal pass through
device. An alternative would be to see if you can locate a cage (non duplexed) for a 4000/4500/5000. The tower cages hold 4 drives, and the rack based ones hold 5. There is no duplexing option for the rack based models. LC "Fabio" wrote in message ... Hi. I have found some weeks ago a proliant 5000 with dual PPRo200, 128M, 4 disk 2.1 gbytes and a duplexing kit. I'd want to eliminate this kit and return to standard scsi configuration, but removing the board installed on the back of the disk backplane is not sufficient In fact the on board controller recognize and spin up only 2 of 4 disks. What i have to do? Thanks Fabio -- + ------------------------------------------+ + E non proferir mai verbo + + che plauda al vizio o la virtu' derida. + +-------------------------------------------+ + Genesis 1000 and now R6 + +-------------------------------------------+ |
Thread Tools | |
Display Modes | |
|
|