If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CL vid driver problem w/ win XP on Visualize workstation
Hi,
I just purchased a used HP Visualize x550 workstation running 2 Xeon PIII 550's/512Mb/9.1Gig Cheetah scsi etc. As this was a used computer it was sold clean, without any OS onboard. I am using the machine primarily for digital audio/video apps and wish to use Win XP. Upon installing XP everything set up as intended except the onboard Cirrus logic 5480 video card, and the on-board Analog Devices 1816A audio, which I am not using anyway. I do not know for certain if the Cirrus is an fx2 or fx4 card??? However, XP only sees the Cirrus logic card but not the associated video driver. It sets me up with a default 16bit color / 800x600 VGA driver and does not allow any further enhancements of the display. The device manager shows the card but also shows a question mark associated with a "video driver" which is not installed. It did the same for the 1816A, but I was able do download a driver and enable it, to at least get rid of the ??? in the system, even though I am not using it. All attempts to find a XP specific compatible "video driver" for the 5480 have failed so far. Part of the problem is that I do NOT have any setup disks or drivers for this workstation, and had to rely on the setup from XP to load any PnP drivers for the system. Obviously, not all required drivers for specific products are resident on XP....If I had an actual driver for the required Cirrus Logic Video Controller it may work perfectly well for XP without any difficulty, as do many of my other programs/hardware. I hope that someone out there who has upgraded a similar system (Visualize x-series, or Kayak) outfitted with a Cirrus Logic card has the required system driver(s) they could forward to me. All indications are that he Cirrus is a kickass video card...It would be a real shame to be unable to make use of it. I have temporarily replaced it with a Creative 3D 32MB card...which works ok, but I can't help but think that I am missing something by not using the Cirrus.... Thanks in advance to anyone who can help. Rainer |
#2
|
|||
|
|||
Obvious suggestion would be to try the HP website, look for drivers by
workstation. and then your model. Mark. "Rainer Wiechmann" wrote in message ... Hi, I just purchased a used HP Visualize x550 workstation running 2 Xeon PIII 550's/512Mb/9.1Gig Cheetah scsi etc. As this was a used computer it was sold clean, without any OS onboard. I am using the machine primarily for digital audio/video apps and wish to use Win XP. Upon installing XP everything set up as intended except the onboard Cirrus logic 5480 video card, and the on-board Analog Devices 1816A audio, which I am not using anyway. I do not know for certain if the Cirrus is an fx2 or fx4 card??? However, XP only sees the Cirrus logic card but not the associated video driver. It sets me up with a default 16bit color / 800x600 VGA driver and does not allow any further enhancements of the display. The device manager shows the card but also shows a question mark associated with a "video driver" which is not installed. It did the same for the 1816A, but I was able do download a driver and enable it, to at least get rid of the ??? in the system, even though I am not using it. All attempts to find a XP specific compatible "video driver" for the 5480 have failed so far. Part of the problem is that I do NOT have any setup disks or drivers for this workstation, and had to rely on the setup from XP to load any PnP drivers for the system. Obviously, not all required drivers for specific products are resident on XP....If I had an actual driver for the required Cirrus Logic Video Controller it may work perfectly well for XP without any difficulty, as do many of my other programs/hardware. I hope that someone out there who has upgraded a similar system (Visualize x-series, or Kayak) outfitted with a Cirrus Logic card has the required system driver(s) they could forward to me. All indications are that he Cirrus is a kickass video card...It would be a real shame to be unable to make use of it. I have temporarily replaced it with a Creative 3D 32MB card...which works ok, but I can't help but think that I am missing something by not using the Cirrus.... Thanks in advance to anyone who can help. Rainer |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
USB Memory Stick: Problem with driver and recognition | Thomas Jerkins | General | 0 | June 1st 04 02:26 PM |
This problem has baffled everyone... | Nick G | General | 46 | May 22nd 04 04:01 AM |
Epson CX3200 driver installation problem | Muhammad Berki | General | 1 | December 23rd 03 03:34 PM |
MSI FX5600 Graphic card - Latest driver problem | John Hellingsworth | General | 1 | September 21st 03 01:17 PM |