|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 8th 04, 11:18 AM
|
|||
|
|||
Heatsink and Fan
Would a heatsink and fan from a Cyrix 166 Mhz Slot 7 CPU work with a Pentium
233 MMX Slot 7 CPU? Rick 
|
|
#2
March 8th 04, 11:40 AM
|
|||
|
|||
|
Rick wrote:
Would a heatsink and fan from a Cyrix 166 Mhz Slot 7 CPU work with a Pentium 233 MMX Slot 7 CPU? Rick It should be fine. Use some sort of thermal grease and you shouldn't have any problems. -- ~misfit~
|
|
#3
March 8th 04, 07:55 PM
|
|||
|
|||
|
On Mon, 8 Mar 2004 11:18:01 -0000, "Rick"
wrote: Would a heatsink and fan from a Cyrix 166 Mhz Slot 7 CPU work with a Pentium 233 MMX Slot 7 CPU? Rick It should be close enough to supporting the heat of the CPU, and it's the same socket, so usually, yes it'll work. Exceptions might be some overly large 'sinks like the OEMs used, that extend past the socket itself and so are blocked by some other motherboard components.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
