If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hyper Threading with IT7(not max)
I'd like to upgrade my CPU to a Hyper thread type. My IT7(not max) with the
Intel 845e chipset is supposed to be able to hyper thread. My board can't run 800mhz, but can run 533mhz. BUT the only P4 with HT that runs 533 is the 3.06mhz. My board claims it can only go to 2.8mhz at 533. Is there any way I can do it? I have the latest D7 Bios installed. Any ideas? MIKE |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stability issues with Cooler Master Hyper 6? | Richard Dower | Homebuilt PC's | 1 | December 19th 04 08:00 PM |
P4: Hyper Threading not active? | Bekin Rata | General | 9 | May 22nd 04 09:23 PM |
Problem w/Win98 & Hyper Threading P4? | 289425 | Homebuilt PC's | 19 | April 15th 04 01:42 AM |
an inexpensive hyper threading supporting mobo | natural_4u | Overclocking | 10 | February 8th 04 05:39 PM |
Kingston Hyper X PC3200 question | Daddy-O | Homebuilt PC's | 2 | August 28th 03 01:15 AM |