|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 18th 03, 02:37 AM
|
|||
|
|||
how to recover my ti4200 bios after a flash failure?
Hi,
I used nvflash to flash the bios of ti4200 and everything was fine until i reboot... black screen (the monitor is ON and not in power saving mode...), no post beep, and no boot... then i plugged a pci video card and i tried to flash my agp card (chaintech a-gt20), but nvflash displays an error message : "COULD NOT ENABLE THE PROM PINS", then stops... if you have any idea please email me... rook from France 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to test psu and reset to cmos to default | Tanya | General | 23 | February 7th 05 09:56 AM |
| IDE RAID- Major problem need to save my data | MC | General | 21 | December 5th 04 05:38 AM |
| flash gigabyte bios | Krzysztof M. | General | 5 | September 25th 04 11:55 PM |
| BIOS Flash problems | Bradley Betz | General | 6 | May 19th 04 06:06 PM |
| Downgrading the BIOS of my p4p800-vm...possible? | KILOWATT | General | 3 | January 2nd 04 08:37 PM |
Linear Mode
