If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
star laserprinter 4 and 4 III
hi,
over here I do have a Star Laserprinter 4 and a 4 III the '4' is working well, the 4 III not, but has an expansion memory board.. would like to take that board and put it in the slot of the '4'.... this doesn't seem to fit, I cannot see why not.. the slots seem identical (peering through the case-opening) are these boards *not* interchangable, or should I be more brutal ;-)) tx, rob (don't have manuals of both machines..) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
***** Quake 4 ***** !!! 5 star rating !!! =D ****** | Skybuck Flying | Nvidia Videocards | 17 | May 31st 06 06:12 PM |
!! Starwars: Empire at war !! | Skybuck Flying | Nvidia Videocards | 10 | February 24th 06 06:15 PM |
HP 7960 vs 8450, b&w, star wheel marks | Tadeusz Galkowski | Printers | 4 | June 20th 05 06:11 PM |
star wintype 4000 | Gray | Printers | 1 | November 28th 04 08:02 PM |
star laserprinter 4: error message? | [email protected] | Printers | 0 | October 13th 04 08:28 PM |