A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » General Hardware & Peripherals » Homebuilt PC's
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

won`t boot up?????



 
 
Thread Tools Display Modes
  #1  
Old July 13th 03, 07:22 AM
Strontium
external usenet poster
 
Posts: n/a
Default won`t boot up?????


-
bren stood up, at show-n-tell, and said:

i turned my computer on today and it won`t boot up,
it powers up ok then stops at the makers logo(packard bell)



You just stated the problem (HP).


pressing
f8 or delete to enter the bios and i`ve even tryied jumping the cmos
but nothing works.
could it be a dead hard drive or something


Read, above.


Seriously, HP's are not very well regarded by those that build their own.
They are on par (quality-wise) with the likes of Gateway and Compaq (same
company, now). Can't help you, as it's a very proprietary system. Get a
Dell, next time.



Any ideas
thanks
Brendan


--
Strontium

"Shortcuts are self-defeating. Mean. If you cannot do it,
clean, you'll never reach your reward..." - 311



  #2  
Old July 13th 03, 01:16 PM
David Matthew Wood
external usenet poster
 
Posts: n/a
Default

i turned my computer on today and it won`t boot up,
it powers up ok then stops at the makers logo(packard bell) pressing f8 or
delete to enter the bios and i`ve even tryied jumping the cmos but nothing
works.
could it be a dead hard drive or something


It's possible. Have you checked all the ribbon and power cables? Have
you listened to see if the hard drive is actually spinning up?
  #3  
Old July 14th 03, 10:24 AM
Strontium
external usenet poster
 
Posts: n/a
Default

Let's see..... You're posing this question to a 'homebuilt' group. Do I
have this right? And, you have the where-withall to be a smartass? Heh!
Welcome to usenet. Hope you enjoy your compaq.....

Now, let's talk about YOU. Shall we?

Hmmmmmmmmmmmmm.... not much to say, really. You, obviously, can't read
(either that, or just a rude, obnoxious person that could care less about
being ON topic). Last, but not least, you ask for help...then flame in
reply to reply. All I can say to that (and others that have used this
medium for quite a while will agree), is that you are a moron.



-
bren stood up, at show-n-tell, and said:

Thanks for the answer. now if someone who knows something about
computers got any ideas it would be great
thanks
Brendan

"Strontium" wrote in message
...

-
bren stood up, at show-n-tell, and said:

i turned my computer on today and it won`t boot up,
it powers up ok then stops at the makers logo(packard bell)



You just stated the problem (HP).


pressing
f8 or delete to enter the bios and i`ve even tryied jumping the cmos
but nothing works.
could it be a dead hard drive or something


Read, above.


Seriously, HP's are not very well regarded by those that build their
own. They are on par (quality-wise) with the likes of Gateway and
Compaq (same company, now). Can't help you, as it's a very
proprietary system. Get a Dell, next time.



Any ideas
thanks
Brendan


--
Strontium

"Shortcuts are self-defeating. Mean. If you cannot do it,
clean, you'll never reach your reward..." - 311


--
Strontium

"Shortcuts are self-defeating. Mean. If you cannot do it,
clean, you'll never reach your reward..." - 311



  #4  
Old July 14th 03, 03:15 PM
jaster
external usenet poster
 
Posts: n/a
Default

Strontium: The OP is correct. He asked for help about his Packard Bell and
your advice was to buy a Dell. There's no need to turn this group into
another alt.os.windows-xp.

OP: If you see the Packard Bell screen the PC is trying to boot. Try
disconnecting hd, fd, cd, etc and reboot to the bios. If you get to the
bios, connect the fd and boot to Memtest86 to check your memory. Possible
causes of your problem dying memory, psu, hd or bad cable connections.
Verify in your manual that F8 is the only key to get to your bios as I some
of those older PC needed F8+Shift.


"Strontium" wrote in message
...
Let's see..... You're posing this question to a 'homebuilt' group. Do I
have this right? And, you have the where-withall to be a smartass? Heh!
Welcome to usenet. Hope you enjoy your compaq.....

Now, let's talk about YOU. Shall we?

Hmmmmmmmmmmmmm.... not much to say, really. You, obviously, can't read
(either that, or just a rude, obnoxious person that could care less about
being ON topic). Last, but not least, you ask for help...then flame in
reply to reply. All I can say to that (and others that have used this
medium for quite a while will agree), is that you are a moron.



-
bren stood up, at show-n-tell, and said:

Thanks for the answer. now if someone who knows something about
computers got any ideas it would be great
thanks
Brendan

"Strontium" wrote in message
...

-
bren stood up, at show-n-tell, and said:

i turned my computer on today and it won`t boot up,
it powers up ok then stops at the makers logo(packard bell)


You just stated the problem (HP).


pressing
f8 or delete to enter the bios and i`ve even tryied jumping the cmos
but nothing works.
could it be a dead hard drive or something

Read, above.


Seriously, HP's are not very well regarded by those that build their
own. They are on par (quality-wise) with the likes of Gateway and
Compaq (same company, now). Can't help you, as it's a very
proprietary system. Get a Dell, next time.



Any ideas
thanks
Brendan

--
Strontium

"Shortcuts are self-defeating. Mean. If you cannot do it,
clean, you'll never reach your reward..." - 311


--
Strontium

"Shortcuts are self-defeating. Mean. If you cannot do it,
clean, you'll never reach your reward..." - 311





 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Can't boot from CD Zotin Khuma General 6 November 16th 04 10:18 PM
Boot problem with Promise SATA Fasttrack S150TX2 Plus Wizard General 0 September 13th 04 06:54 PM
Hard drive will not boot Dave General 1 March 9th 04 06:16 PM
Disk Boot Failure problem atDFN General 2 February 8th 04 07:51 PM
Hard drive that boots elsewhere refuses to boot in this machine Simon O'Connor General 9 July 22nd 03 06:34 AM


All times are GMT +1. The time now is 10:13 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.