If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#5
|
|||
|
|||
"BigBadger" wrote in message ... Yes, there is something 'special' about 200MHz. The KT600 chip-set used on the board in question does not have locked AGP and PCI busses, therefore the only way to keep the PCI and AGP in spec is to run at the 'official' FSB bus speeds i.e. 100, 133, 166 or 200MHz. However, a +/- 10% variation around the specified speed, with any luck, is unlikely to cause too many problems. A good XP2600+ Barton will do 200MHz no problem. My old one did 220MHz on air cooling. You are damn right! You sure do know something I set my FSB to 200MHz...surprisingly it booted up no problem but I need to change the multiplier down to 11 from 11.5 just to ease it up a bit. Mobo recognised it as 3200+ now. But unfortunately it cannot boot up windows (it would go blank and reset the system) because the CPU goes up to the 60Cs :/ Just need to get better cooling. Any suggestions? 80mm or 60mm fan? Would air cooling with a good heatsink help? Thanks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AMD overclocking and semperon 3100s | [email protected] | General | 0 | November 24th 04 01:02 PM |
6800 Ultra overclocking - XFX? PNY? eVGA? BFG? | Marc Brown | General | 2 | September 29th 04 04:50 PM |
ABIT AI7 - Pentium®4 - 2.6GHz - Overclocking advice :) | Wayne Youngman | Overclocking | 23 | April 19th 04 12:02 PM |
Opinion needed on new AMD system and overclocking ability | Bill | Overclocking AMD Processors | 11 | November 21st 03 07:15 PM |
OverClocking Guides | Phil Weldon | Overclocking | 0 | August 15th 03 05:41 AM |