If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Smartstart problem on Proliant 400
Hi folks,
When I perform an assisted install using SmartStart (thanks LC), everything works fine until the very last step: the server hangs on the screen "installing and configuring Compaq utilities". I can only force a shutdown and restart, but then the NT installation starts all over again... What's wrong? Thanks, Onnotche |
#2
|
|||
|
|||
Thanks a lot, I'll give it a try
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help needed with unidentified problem | ^MisterJingo^ | General | 3 | November 23rd 04 06:45 AM |
ATI Radeon 8500 problem (or the ViewSonice A90f+ monitor problem)?? | T.T. | Ati Videocards | 0 | October 9th 04 07:19 PM |
Mouse Problem | Jeff | Homebuilt PC's | 0 | October 1st 04 06:44 AM |
not the same old B&W problem (I don't think) | Brian Lee | Ati Videocards | 0 | July 9th 04 01:15 AM |
Directx Problem Solved | Me | Nvidia Videocards | 1 | August 23rd 03 06:32 AM |