|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 3rd 04, 11:43 PM
|
|||
|
|||
Control Center or Control Panel?
Is it worth getting the .net framework drivers and control center? does it
allow custom resolutions ? 
|
|
#2
December 4th 04, 12:50 AM
|
|||
|
|||
|
|
|
#3
December 4th 04, 01:11 AM
|
|||
|
|||
|
"mikea" wrote in message ... Is it worth getting the .net framework drivers and control center? does it allow custom resolutions ? I saw no real benefit, and I don't think it did anything the regular control panel couldn't do except take up a substantial amount of memory.
|
|
#4
December 4th 04, 02:05 AM
|
|||
|
|||
|
"mikea" wrote in message ... Is it worth getting the .net framework drivers and control center? does it allow custom resolutions ? Stick with the old Control Panel. I haven't read one good thing about CC. JLC
|
|
#5
December 4th 04, 12:19 PM
|
|||
|
|||
|
"JLC" wrote in message news:zX8sd.436693$wV.245458@attbi_s54... "mikea" wrote in message ... Is it worth getting the .net framework drivers and control center? does it allow custom resolutions ? Stick with the old Control Panel. I haven't read one good thing about CC. JLC Thanks for the info, but being a bit ditzy, can you tell me how to revert back to the vanilla version of CC? Cheers Lynne
|
|
#6
December 4th 04, 01:17 PM
|
|||
|
|||
|
"Lynne" wrote in message ... "JLC" wrote in message news:zX8sd.436693$wV.245458@attbi_s54... "mikea" wrote in message ... Is it worth getting the .net framework drivers and control center? does it allow custom resolutions ? Stick with the old Control Panel. I haven't read one good thing about CC. JLC Thanks for the info, but being a bit ditzy, can you tell me how to revert back to the vanilla version of CC? Cheers Lynne I'm pretty sure you just go to Add/Remove Programs in Control Panel (the windows one that is). IIRC it will revert to the old ATI CP, unless you uninstalled it.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pc problems after g card upgrade + sp2 | ben reed | Homebuilt PC's | 9 | November 30th 04 01:04 AM |
| Do I have to un-install Control Panel to install Control Center? | William Cheng | Ati Videocards | 0 | November 23rd 04 06:29 AM |
| catalyst 4.9 control center | bob brozewicz (news group) | Ati Videocards | 2 | September 26th 04 03:11 AM |
| Problems with all versions of Catalyst down to 4.6, and the control panel seems to be the bad guy | Jimi Hullegård | Ati Videocards | 1 | September 21st 04 06:24 PM |
| Catalyst Control Center installation question | Frederick Pileggi | Ati Videocards | 8 | September 9th 04 12:16 AM |
Linear Mode
