If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CD Burners: faster burn speed increase mtbf ?
I heard on radio that the lifespan of a CD burner was related to how much
time the laser was actually burning a CD, so if you burnt at x52 speed the laser would last longer vs burning at x8 or x16. Burning at x52 speed laser will be used for a lot less time for each CD burnt so last longer ? |
#2
|
|||
|
|||
makes sense
"Tinklemagoo" wrote in message ... I heard on radio that the lifespan of a CD burner was related to how much time the laser was actually burning a CD, so if you burnt at x52 speed the laser would last longer vs burning at x8 or x16. Burning at x52 speed laser will be used for a lot less time for each CD burnt so last longer ? |
#3
|
|||
|
|||
I would think that the laser is 'on' only when it needs to burn a
hole in the media for a bit. Therefore, how much the laser is 'on' is data dependent and not writing speed dependent. Tinklemagoo wrote: I heard on radio that the lifespan of a CD burner was related to how much time the laser was actually burning a CD, so if you burnt at x52 speed the laser would last longer vs burning at x8 or x16. Burning at x52 speed laser will be used for a lot less time for each CD burnt so last longer ? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Metabench? -- Can MEMTEST86+ check memory running at faster bus speed? | Mixxy | General | 0 | October 15th 04 11:11 AM |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
Synchronize vs. non-synchronize FSB/Memory speed? | Ohaya | Overclocking AMD Processors | 0 | March 11th 04 08:11 AM |
FSB settings increase memory speed? | GlueGum | Overclocking AMD Processors | 2 | February 4th 04 01:35 AM |
What makes it faster? Lower latency or higher bus speed? | Daniel Gomes | Overclocking | 0 | July 26th 03 01:41 AM |