If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
My P4 2.53 @ 3.06 w/ pc2100 is that all ?
Actually I upped my voltage to the cpu to 1.60 (as high as the board would let me),and also upped the ddr voltage to 2.7. Upping the ddr voltage is what seems to have made it stable. I'm running on an Asus P4S800, and it doesn't allow me to lower the bus.
I had stated the FSB was 167 its actually 161 and with that choice the PCI bus is at 41mhz but if i could get to the 164 that is where the bus drops back to 33. And being that the temps seem to be so nice i was hoping i could push it a little further. So it could be a ****ibility that this is as high as the motherboard will let me go? Thanks..... choppo |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PC2100 w/ 333 MHz Barton and Soyo KT600 Ultra PE | anybody | General | 4 | September 18th 04 03:52 PM |
Dumb thing and mixing PC2100 and PC2700 DDR RAM [long] | David W.E. Roberts | General | 1 | August 6th 04 12:18 PM |
Dumb thing - and mixing memory PC2100 and PC2700 - and WHAT??? | David W.E. Roberts | General | 3 | August 5th 04 02:39 PM |
My P4 2.53 @ 3.06 w/ pc2100 is that all ? | Overclocking | 1 | October 6th 03 09:28 AM | |
P4 3.06 GHz Temps at 50C idle!!! | Justin Horne | Overclocking | 6 | August 24th 03 08:59 PM |