If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
In message 1111239174.47ce61afaea273dc706ecc7637993a71@teran ews,
mikep187 writes I want to replace the chipset fan on my GA-K8NS Ultra-939 for something quieter. I know there's not much clearance between the heatsing and AGP card. Has anyone found a replacement heatsink and fan or even a silent fan that would be suitable? On my 7VAXP Ultra I simply removed the chipset fan, with no problems. -- Mick |
#2
|
|||
|
|||
I got a big blue Zalman passive heatsink for it but haven't put it on yet. I
put the mb in stock in case I'd have to send it back. So I'll have to take it all out to put on the heatsink. Can't hear the little fan on mine -- but then, I have the case lined with PaxMate. -- Ed Light Smiley :-/ MS Smiley :-\ Send spam to the FTC at Thanks, robots. |
#3
|
|||
|
|||
GA-K8NS Ultra-939 chipset fan replacement.
I want to replace the chipset fan on my GA-K8NS Ultra-939 for
something quieter. I know there's not much clearance between the heatsing and AGP card. Has anyone found a replacement heatsink and fan or even a silent fan that would be suitable? |
#4
|
|||
|
|||
mikep187 wrote:
I want to replace the chipset fan on my GA-K8NS Ultra-939 for something quieter. I know there's not much clearance between the heatsing and AGP card. Has anyone found a replacement heatsink and fan or even a silent fan that would be suitable? you can hear the chipset fan?? good ears. With the hum from the CPU fan, 2 fans from 500W power supply, and 3 case fans (80 cm, ball bearing, 2 x 24 CFM 1 x 40 CFM), and the old AMD K6-2 cpu fan and heatsink I pu on my G4 Ti4800, I can't hear the dinky little chipset fan! GA-k8ns-939 AMD64 3000+ 512MB Mushkin G4 Ti4800 |
#5
|
|||
|
|||
I know there's not much clearance between the
heatsing and AGP card. I determined that the big blue Zalman would just fit, or I could nibble a corner off the fins. -- Ed Light Smiley :-/ MS Smiley :-\ Send spam to the FTC at Thanks, robots. |
#6
|
|||
|
|||
On Sun, 20 Mar 2005 13:05:14 -0800, "Ed Light"
wrote: I know there's not much clearance between the heatsing and AGP card. I determined that the big blue Zalman would just fit, or I could nibble a corner off the fins. Thats what I was thinking of ordering also, even if trimming was needed. I have GA-K8NS Ultra-939 with a Athalon64 3500+ overclocked to 2400mhz via overclocked 218 mhz fsb. Will I have heat issues with the northbridge, or if needed maybe I could mount a slow running 40mm fan over it. |
#7
|
|||
|
|||
endpcnoise says:
We have not had any issues using them in the past, but just as the product support page says ( http://www.zalmanusa.com/usa/product...dx=71&code=014 ) the Northbridge is only compatible when used on a Northbridge located between the CPU and AGP (or PCIe) slot, and make certain to use a good cpu cooler like a 7700 to increase airflow around the Northbridge chipset. Hope this helps So, hmmm... But I guess it just needs ok airflow, from a nearby fan, or general flow in the case. I thought I'd see how hot it gets to the touch. But now I'm off on a trip and won't be back to newsgroups until mid-April. Sayonara! -- Ed Light Smiley :-/ MS Smiley :-\ Send spam to the FTC at Thanks, robots. |
#8
|
|||
|
|||
On Thu, 24 Mar 2005 11:59:05 -0800, "Ed Light"
wrote: endpcnoise says: We have not had any issues using them in the past, but just as the product support page says ( http://www.zalmanusa.com/usa/product...dx=71&code=014 ) the Northbridge is only compatible when used on a Northbridge located between the CPU and AGP (or PCIe) slot, and make certain to use a good cpu cooler like a 7700 to increase airflow around the Northbridge chipset. Hope this helps So, hmmm... But I guess it just needs ok airflow, from a nearby fan, or general flow in the case. I thought I'd see how hot it gets to the touch. But now I'm off on a trip and won't be back to newsgroups until mid-April. Sayonara! Update, I ordered a 50mm cpu fan and am running it at 5 volts, I also put some video ram heatsinks on the open area of the heatsink. The fan fit with little effort and easily clears the agp card. Iwas able to mount it with some screws I had laying around. So far no heat issues even when playing Half Life 2 with the overclocked cpu and Video card (GEforce 6600GT), or running the cpu at full load (Distributed.net). Made a big difference in noise levels also. I am planning on putting 1 or 2 more small heatsinks to fill the open area on there for hopfully even better cooling. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HELP! Please!!! ...ASUS V9980 Ultra Nvidia FX5950 Chipset | BigSie | Nvidia Videocards | 5 | September 28th 04 12:34 PM |
Scarcity of High Speed, Ultra Speed, and Ultra Speed Plus CDRW media? | Dave Cohen | Cdr | 1 | April 9th 04 10:30 PM |
OCZ Ultra II thermal paste recall | FelixC | Overclocking | 2 | February 17th 04 04:52 PM |
Please (help with/review) my new AMD PC build.... | Darth Joules | General | 2 | December 26th 03 09:06 AM |
Mainboard on i440BX chipset by IBM PC 300PL 6862-80U: (CPU/BIOS problem) | YevgeniyPro | General | 0 | July 25th 03 10:38 PM |