If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
No POST
MB: New A7N8X-X
I'm getting the same results with my new Asus board as I did with a new Epox board (sent back per Epox support). Boards won't run POST, no beep. After power is turned on, case fans run, and monitor goes into sleep mode after about 8 secs. If I take the IDE cable from IDE 1, place in IDE 2, the board POSTs and boots completely. Then, on reboot, same failure occurs. If I place IDE cable back to IDE 1, failure occurs again. Then placing IDE cable from IDE 1 to IDE 2, again, board POSTs and computer boots completely. That is the pattern. I've tried a different new IDE cable and get the same results with or without the CD-ROM attached to the cable. I'm stumped, at this point. Could it be the hard drive? It seems weird for the HD to be bad if it boots up at any point during the pattern above. Any wisdom here, from the wise, is appreciated... . |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
516570473687 money 516570473687 | RASCH | Abit Motherboards | 0 | February 15th 04 03:57 AM |
575312570444 money 575312570444 | RASCH | Cdr | 0 | February 15th 04 03:57 AM |
828757005758 money 828757005758 | RASCH | General | 0 | February 14th 04 10:15 PM |
063124043334 money 063124043334 | RASCH | Overclocking AMD Processors | 0 | February 14th 04 10:15 PM |
010813603026 money 010813603026 | RASCH | Overclocking AMD Processors | 0 | February 14th 04 10:15 PM |