If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
P4P800-E "overclocking failed" msg driving me nuts
Put a system together using the P4P800-E and it runs fine. Overclocks
a 3.4 Gig processor to 3.7 without any voltage adjustment. But there's a "feature" that's driving me nuts. It seems that sometimes when I reboot I get a message saying "overclocking failed" even though it didn't fail. If I go into the cmos and then save the settings without making any changes, everything is fine. I think it happens when the machine doesn't go through a full post test because I was messing around with a boot floppy and turning the system on and off a lot when I noticed it. Is there some way to disable this "overclocking failed" message? Thanks for any help. |
#2
|
|||
|
|||
Try with a new power-supply. I had a same problem and it turned out to be a
defective PS, defect was present ONLY during reboot, it rebooted twice during reboot sequence and BIOS detected that as "Overclock failure". |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
"Overclocking failed" but no overclocking attempted | jbgcjncg | Overclocking AMD Processors | 7 | November 17th 05 12:33 AM |
Xscale overclocking failed!!! HELP | TObbyy | Overclocking | 0 | December 15th 04 04:01 PM |
p4p800 deluxe P4-2.4-C overclocking problems | dorgold | Overclocking | 2 | March 28th 04 03:30 PM |
System failed due to overclocking? | Dirty Harry | Overclocking AMD Processors | 1 | October 27th 03 05:40 PM |
OverClocking Guides | Phil Weldon | Overclocking | 0 | August 15th 03 05:41 AM |