If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
GA 8Knxp Ultra 64
I am trying to install Win XP on SATA 0 and when I go through win setup, no
drives are shown to install on... I see drive in bios, but not after setup. I have tried loading drivers using F4 during setup, and several different bios configurations. What is the correct procedure? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Scarcity of High Speed, Ultra Speed, and Ultra Speed Plus CDRW media? | Dave Cohen | Cdr | 1 | April 9th 04 10:30 PM |
8KNXP Ultra SCSI RAID-0 Hibernate problem | Pavel | Gigabyte Motherboards | 1 | January 28th 04 06:44 PM |
8knxp Ultra SCSI boot problem | Gevorg | Gigabyte Motherboards | 5 | January 21st 04 08:09 AM |
8KNXP Ultra - SCSI boot question | Jerome Williams | Gigabyte Motherboards | 7 | December 6th 03 07:53 PM |
8KNXP slow copying over LAN | Scott | Gigabyte Motherboards | 3 | September 2nd 03 10:54 PM |