If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
installing a new card?
Hi,
I just got a new Radeon 9600, and as a newbie, I was wondering what exactly are the steps to take to install the card. - Do I un-install the old driver through the Add/Remove programs? Does that suffice? Some tips suggest going through the BIOS. How exactly do I do that? - What is "Flashing" the BIOS? What does it do? - Are the Catylyst 3.4 the de-facto standard for the new cards? Thanks a lot, Sumedh |
#2
|
|||
|
|||
Using add/remove on the old card's drivers ought to be adequate. (I have
seen utilities for removing all traces of old drivers, but I haven't used them. I went from an nVidia GF4 4200 to an ATI Radeon 9700 Pro a few months ago - after the 9700 dropped in price - with no difficulty.) I don't understand what BIOS settings would have to do with it. The BIOS is the Basic Input/Output System. It contains the code needed to start up and run the PC. "Flashing" the BIOS is updating the code, which resides on an EEPROM (electrically erasable programmable read only memory) chip. You flash the BIOS to fix errors in it, add new features, support new processors, etc. The main reason to *not* casually upgrade the BIOS is that if something goes wrong with the flash, the machine my not be usable until new EEPROM chip is installed with a working BIOS. (Most PCs use a socketed BIOS chip, so it can be done without soldering. I've never had to do it, though.) Some PCs have BIOS recovery features built-in, but I haven't used mine. The Catalyst 3.4 drivers are the latest unified driver release for the Radeon cards. (They're equivalent to the nVidia "Detonator" drivers, although ATI strongly discourages the distribution of leaked beta versions. I sort of miss that.) Rumor has it that the Catalyst 3.5 drivers will be released on Monday, 26 June. HTH. Bob Knowlden Spam dodger may be in use. Replace nkbob with bobkn. "Sumedh" wrote in message om... Hi, I just got a new Radeon 9600, and as a newbie, I was wondering what exactly are the steps to take to install the card. - Do I un-install the old driver through the Add/Remove programs? Does that suffice? Some tips suggest going through the BIOS. How exactly do I do that? - What is "Flashing" the BIOS? What does it do? - Are the Catylyst 3.4 the de-facto standard for the new cards? Thanks a lot, Sumedh |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
8X APG not working | shmortz | Asus Motherboards | 6 | December 8th 04 11:57 PM |
Flash card reader: write problem... | KILOWATT | General | 7 | June 1st 04 12:19 AM |
TV tuner card for LCD | Stacey | General | 15 | April 4th 04 03:06 AM |
Problems installing ALI USB 2.0 / IEEE1394 multi-port USB / Firewire pci card | Hans H jakobsen | General | 2 | March 31st 04 10:57 AM |
Add PCI card gives 1 Long 2 Short Beeps | Jane Tweedynn | General | 5 | October 6th 03 01:15 AM |