|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 1st 06, 02:20 AM
posted to alt.comp.mainboards.abit
|
|||
|
|||
eay (I hope) question
I have an BE6 motherboard with on-board highpoint HPT UDMA-66
controllers. I have purchased a promise UDMA-100 card for this computer, and was wondering if there is anything I have to do in the bios? One one channel, the one that comes up in the boot shows a cdrw and cd. This is all that is shown until this final secs then it shows the HD C and D. Any help is most appreciated. Michael 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Good morning or good evening depending upon your location. I want to ask you the most important question of your life. Your joy or sorrow for all eternity depends upon your answer. The question is: Are you saved? It is not a question of how good | Remnant Banana | General | 5 | April 23rd 05 02:40 AM |
| A question about dual monitors | Woodsy | General | 1 | March 11th 05 06:17 AM |
| couple of Dimension XPS Gen4 question | Matt | Dell Computers | 3 | March 4th 05 02:20 AM |
| Question - Printing 2-up on 11x17 | Don | Printers | 1 | August 24th 03 04:27 AM |
| Home PC DVD burner Question. | Ruben | General Hardware | 2 | August 18th 03 05:29 PM |
Linear Mode
