|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 28th 04, 04:52 PM
|
|||
|
|||
RAID 1 newbie question - non identical disks
Hi,
I have a 120GB IBM Deskstar and after being concerned that it might bite the dust in the future (heard some dodgy stories about deathstars) I want to set up a RAID 1 array. I bought a Seagate 120GB drive since I didn;t want another IBM. My question is would I be able to use this Seagate disk to mirror the IBM as the BIOS reports the IBM size as 117XXX in size and the Seagate 114XXX in size. Is there any way theyre gonna work together? Thanks in advance, Matt 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie Question re hardware vs software RAID | Gilgamesh | General | 44 | November 22nd 04 10:52 PM |
| Raid question | S.Boardman | General | 10 | November 18th 04 05:08 PM |
| Raid 0 with 3 Hard Disks? | Thomas Krause | General | 2 | October 22nd 04 12:20 AM |
| Single Hard Drive Raid Setup Question | Chris | Homebuilt PC's | 9 | July 30th 04 09:00 PM |
| Abit RAID question | John | General | 2 | January 1st 04 04:19 PM |
Threaded Mode