If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Problem with MSI Personal Cinema FX5200
Since I installed new versions of the driver software PersonalCinema_45.33
and 2.13-VIVO_TV (download from msi), the software stopped working. The WinDVR hangs on the splash window and never starts. All other capture software and NVDVD hangs on initialization as well. Anyone any ideas? System: Chaintech 6BTS Pentium IIII Powerstrip info: Diagnostic report - generated on 20-10-2003 ---------------------------------------------------------------------------- -- PowerStrip build - 410 Windows build - v.5.1.2600.2.Service Pack 1 DirectX build - v.5.1.2600.1106 (xpsp1.020828-1920) OpenGL renderer - (n/a) System board ---------------------------------------------------------------------------- -- CPU speed - 652 MHz Type - Intel i440BX-W977TF-2A69KC39C-00 BIOS - Award Bios, 07/23/1999 AGP aperture - 32 MB AGP transfer mechanism - DMA AGP non-local memory - 124,0 MB AGP revision - 1.00 AGP transfer rates supported - 1x, 2x Current AGP transfer rate - 2x Sideband addressing - Enabled Fast write protocol - (n/a) AGP texturing - Enabled Graphics card #1 ---------------------------------------------------------------------------- -- Identity - NVIDIA GeForce FX 5200 Memory clock - 405,00 MHz Engine clock - 249,75 MHz IRQ - 11, shared AGP revision - 3.00 AGP transfer rates supported - 1x, 2x, 4x Current AGP transfer rate - 2x Sideband addressing - Enabled Display driver - nv4_disp.dll, v.6.14.10.4523 DirectX driver - nv4_disp.dll, v.6.14.10.4523 Attached monitor - Default Monitor (Microsoft) Monitor caps (1) - 1600x1200, 75kHz, 85Hz Device enumeration ---------------------------------------------------------------------------- -- NVIDIA GeForce FX 5200 (032210DEh) - using IRQ11 Intel CPU-to-PCI/AGP bridge (71908086h) Intel PCI-to-PCI/AGP bridge (71918086h) Intel PCI-to-ISA bridge (71108086h) Intel IDE controller (71118086h) Intel Universal serial bus (USB) (71128086h) - using IRQ10 Intel Power management controller (71138086h) Adaptec SCSI controller (80789004h) - using IRQ9 VIA Universal serial bus (USB) (30381106h) - using IRQ11 VIA Universal serial bus (USB) (30381106h) - using IRQ5 VIA Universal serial bus (USB) (31041106h) - using IRQ9 Realtek Ethernet controller (813910ECh) - using IRQ5 Creative Labs Audio device (00021102h) - using IRQ9 Creative Labs Input controller (70021102h) |
#2
|
|||
|
|||
Did you install the MSI video drivers or the NVIDIA generic drivers from the
NVIDIA website? regards B "Wim The" wrote in message ... Since I installed new versions of the driver software PersonalCinema_45.33 and 2.13-VIVO_TV (download from msi), the software stopped working. The WinDVR hangs on the splash window and never starts. All other capture software and NVDVD hangs on initialization as well. Anyone any ideas? System: Chaintech 6BTS Pentium IIII Powerstrip info: Diagnostic report - generated on 20-10-2003 -------------------------------------------------------------------------- -- -- PowerStrip build - 410 Windows build - v.5.1.2600.2.Service Pack 1 DirectX build - v.5.1.2600.1106 (xpsp1.020828-1920) OpenGL renderer - (n/a) System board -------------------------------------------------------------------------- -- -- CPU speed - 652 MHz Type - Intel i440BX-W977TF-2A69KC39C-00 BIOS - Award Bios, 07/23/1999 AGP aperture - 32 MB AGP transfer mechanism - DMA AGP non-local memory - 124,0 MB AGP revision - 1.00 AGP transfer rates supported - 1x, 2x Current AGP transfer rate - 2x Sideband addressing - Enabled Fast write protocol - (n/a) AGP texturing - Enabled Graphics card #1 -------------------------------------------------------------------------- -- -- Identity - NVIDIA GeForce FX 5200 Memory clock - 405,00 MHz Engine clock - 249,75 MHz IRQ - 11, shared AGP revision - 3.00 AGP transfer rates supported - 1x, 2x, 4x Current AGP transfer rate - 2x Sideband addressing - Enabled Display driver - nv4_disp.dll, v.6.14.10.4523 DirectX driver - nv4_disp.dll, v.6.14.10.4523 Attached monitor - Default Monitor (Microsoft) Monitor caps (1) - 1600x1200, 75kHz, 85Hz Device enumeration -------------------------------------------------------------------------- -- -- NVIDIA GeForce FX 5200 (032210DEh) - using IRQ11 Intel CPU-to-PCI/AGP bridge (71908086h) Intel PCI-to-PCI/AGP bridge (71918086h) Intel PCI-to-ISA bridge (71108086h) Intel IDE controller (71118086h) Intel Universal serial bus (USB) (71128086h) - using IRQ10 Intel Power management controller (71138086h) Adaptec SCSI controller (80789004h) - using IRQ9 VIA Universal serial bus (USB) (30381106h) - using IRQ11 VIA Universal serial bus (USB) (30381106h) - using IRQ5 VIA Universal serial bus (USB) (31041106h) - using IRQ9 Realtek Ethernet controller (813910ECh) - using IRQ5 Creative Labs Audio device (00021102h) - using IRQ9 Creative Labs Input controller (70021102h) |
#3
|
|||
|
|||
From the msi site. Windows complains about the missing signing on the video
driver and does not complain about missing signs on the capture drivers. thanks for your quick response. Wim. "B" wrote in message ... Did you install the MSI video drivers or the NVIDIA generic drivers from the NVIDIA website? regards B "Wim The" wrote in message ... Since I installed new versions of the driver software PersonalCinema_45.33 and 2.13-VIVO_TV (download from msi), the software stopped working. The WinDVR hangs on the splash window and never starts. All other capture software and NVDVD hangs on initialization as well. Anyone any ideas? System: Chaintech 6BTS Pentium IIII Powerstrip info: Diagnostic report - generated on 20-10-2003 -------------------------------------------------------------------------- -- -- PowerStrip build - 410 Windows build - v.5.1.2600.2.Service Pack 1 DirectX build - v.5.1.2600.1106 (xpsp1.020828-1920) OpenGL renderer - (n/a) System board -------------------------------------------------------------------------- -- -- CPU speed - 652 MHz Type - Intel i440BX-W977TF-2A69KC39C-00 BIOS - Award Bios, 07/23/1999 AGP aperture - 32 MB AGP transfer mechanism - DMA AGP non-local memory - 124,0 MB AGP revision - 1.00 AGP transfer rates supported - 1x, 2x Current AGP transfer rate - 2x Sideband addressing - Enabled Fast write protocol - (n/a) AGP texturing - Enabled Graphics card #1 -------------------------------------------------------------------------- -- -- Identity - NVIDIA GeForce FX 5200 Memory clock - 405,00 MHz Engine clock - 249,75 MHz IRQ - 11, shared AGP revision - 3.00 AGP transfer rates supported - 1x, 2x, 4x Current AGP transfer rate - 2x Sideband addressing - Enabled Display driver - nv4_disp.dll, v.6.14.10.4523 DirectX driver - nv4_disp.dll, v.6.14.10.4523 Attached monitor - Default Monitor (Microsoft) Monitor caps (1) - 1600x1200, 75kHz, 85Hz Device enumeration -------------------------------------------------------------------------- -- -- NVIDIA GeForce FX 5200 (032210DEh) - using IRQ11 Intel CPU-to-PCI/AGP bridge (71908086h) Intel PCI-to-PCI/AGP bridge (71918086h) Intel PCI-to-ISA bridge (71108086h) Intel IDE controller (71118086h) Intel Universal serial bus (USB) (71128086h) - using IRQ10 Intel Power management controller (71138086h) Adaptec SCSI controller (80789004h) - using IRQ9 VIA Universal serial bus (USB) (30381106h) - using IRQ11 VIA Universal serial bus (USB) (30381106h) - using IRQ5 VIA Universal serial bus (USB) (31041106h) - using IRQ9 Realtek Ethernet controller (813910ECh) - using IRQ5 Creative Labs Audio device (00021102h) - using IRQ9 Creative Labs Input controller (70021102h) |
#4
|
|||
|
|||
Okay, everything is working after installing the latest DirectX 9b stuff.
Some parts of the driver control was probably messed up. TV Picture quality is now acceptable as well. Finally. "B" wrote in message ... Did you install the MSI video drivers or the NVIDIA generic drivers from the NVIDIA website? regards B "Wim The" wrote in message ... Since I installed new versions of the driver software PersonalCinema_45.33 and 2.13-VIVO_TV (download from msi), the software stopped working. The WinDVR hangs on the splash window and never starts. All other capture software and NVDVD hangs on initialization as well. Anyone any ideas? System: Chaintech 6BTS Pentium IIII Powerstrip info: Diagnostic report - generated on 20-10-2003 -------------------------------------------------------------------------- -- -- PowerStrip build - 410 Windows build - v.5.1.2600.2.Service Pack 1 DirectX build - v.5.1.2600.1106 (xpsp1.020828-1920) OpenGL renderer - (n/a) System board -------------------------------------------------------------------------- -- -- CPU speed - 652 MHz Type - Intel i440BX-W977TF-2A69KC39C-00 BIOS - Award Bios, 07/23/1999 AGP aperture - 32 MB AGP transfer mechanism - DMA AGP non-local memory - 124,0 MB AGP revision - 1.00 AGP transfer rates supported - 1x, 2x Current AGP transfer rate - 2x Sideband addressing - Enabled Fast write protocol - (n/a) AGP texturing - Enabled Graphics card #1 -------------------------------------------------------------------------- -- -- Identity - NVIDIA GeForce FX 5200 Memory clock - 405,00 MHz Engine clock - 249,75 MHz IRQ - 11, shared AGP revision - 3.00 AGP transfer rates supported - 1x, 2x, 4x Current AGP transfer rate - 2x Sideband addressing - Enabled Display driver - nv4_disp.dll, v.6.14.10.4523 DirectX driver - nv4_disp.dll, v.6.14.10.4523 Attached monitor - Default Monitor (Microsoft) Monitor caps (1) - 1600x1200, 75kHz, 85Hz Device enumeration -------------------------------------------------------------------------- -- -- NVIDIA GeForce FX 5200 (032210DEh) - using IRQ11 Intel CPU-to-PCI/AGP bridge (71908086h) Intel PCI-to-PCI/AGP bridge (71918086h) Intel PCI-to-ISA bridge (71108086h) Intel IDE controller (71118086h) Intel Universal serial bus (USB) (71128086h) - using IRQ10 Intel Power management controller (71138086h) Adaptec SCSI controller (80789004h) - using IRQ9 VIA Universal serial bus (USB) (30381106h) - using IRQ11 VIA Universal serial bus (USB) (30381106h) - using IRQ5 VIA Universal serial bus (USB) (31041106h) - using IRQ9 Realtek Ethernet controller (813910ECh) - using IRQ5 Creative Labs Audio device (00021102h) - using IRQ9 Creative Labs Input controller (70021102h) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help needed with unidentified problem | ^MisterJingo^ | General | 3 | November 23rd 04 05:45 AM |
ATI Radeon 8500 problem (or the ViewSonice A90f+ monitor problem)?? | T.T. | Ati Videocards | 0 | October 9th 04 07:19 PM |
Mouse Problem | Jeff | Homebuilt PC's | 0 | October 1st 04 06:44 AM |
not the same old B&W problem (I don't think) | Brian Lee | Ati Videocards | 0 | July 9th 04 01:15 AM |
Corrupt reboot gamma settings.. anyone figure this problem out? | Gareee© | Ati Videocards | 0 | June 13th 04 04:21 PM |