If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
DOS window problem
Hello,
I have an NVIDIA GEFORCE 9100 running under W7 Pro in an HP p6310f. Runs fine except that when I try to use the command prompt the DOS window fills the screen vertically, but only about 2/3 horizontally. I'd like it to fill the screen completely. Clues, please? -- JF |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
System Can't Get Past Black DOS Window bco Bad Floppy Drive? | (PeteCresswell) | Asus Motherboards | 1 | October 22nd 10 09:58 PM |
HydraVision window control problem | Aaron Campbell | Ati Videocards | 0 | September 1st 04 03:10 PM |
Sapphire 9800pro Active window erases Inactive window | mudz | Ati Videocards | 0 | June 1st 04 02:34 PM |
Window encountered a fatal problem calling a PnP BIOS function | half_pint | General | 10 | April 26th 04 03:10 AM |
NTFS / DOS Problem | Wayne Nye | Homebuilt PC's | 1 | February 15th 04 06:06 PM |