If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cant get new board to boot windows
Sorry if this appears twice, I did not get the posted confirmation
screen on first attempt. ------------------------------------------ I am upgrading a AMD 1.4 Aus system to an AMD64 cpu with Gigabyte K8NS Pro motherboard. I am reusing the 2 IDE drives(windows XP already installed)NON-raid, 1 DVD RW and CDRom. All plugs and cables are correctly connected. Boot starts OK. It shows the IDE devices listed correctly, but gets to a gigraid screen and says "doing IDE scan" and then it finds zero devices and cant boot Windows XP. Drives have power and i can see their access lites some on when i do certain things in bios settings. I figure it is configured as a raid system by default? And I need to reconfigure the board in some way, but I cannot find anything in the manual or online on how to fix this. Tried various things in bios configure menus but nothing works. Any suggestions? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A7S333, 2200+ won't boot windows XP -- update | Bryan Schwerer | Asus Motherboards | 4 | July 21st 04 02:07 PM |
Getting a single SATA drive to act as boot device on A7V600-X board | Phil Thompson | Asus Motherboards | 15 | June 14th 04 02:18 PM |
KR7A-RAID and KG7A-RAID boot problem with Athlon XP 2000 | Bob Bagnall | Abit Motherboards | 1 | May 22nd 04 01:32 AM |
Board with USB boot capability? | N | Asus Motherboards | 10 | February 29th 04 06:40 PM |
Multi-boot Windows XP without special software | Timothy Daniels | General | 11 | December 12th 03 05:38 AM |