If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
[91.31] Baloon & Clone mode FIXED
It work for me.
You have single monitor? Then you have the damn baloon at each boot.... and than you cannot run the monitor optimization.. Right? I've fixed in a very simply way.. I've disconnected my CRT (with vga connector) from the VGA connector of the card... and connected it to the other DVI connector with adapter. Result? No more ballon, and no more Clone mode message when trying to optimize monitor by nvidia drivers Hope this help! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AIW 2006 clone mode | Super Giraffe | Ati Videocards | 1 | May 19th 06 07:38 PM |
Mixed mode cd's? | smh | Cdr | 0 | April 17th 06 09:25 PM |
Seagate Barracuda 160 GB IDE becomes corrupted. RMA? | Dan_Musicant | Storage (alternative) | 79 | February 28th 06 08:23 AM |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
Power Surge | David LeBrun | General | 44 | September 12th 03 02:35 AM |