|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 29th 05, 05:45 PM
|
|||
|
|||
AIW 9800 Channel Detection Wizard Problem
I have just changed over from using an ATI Theater 550 Pro. The
Theater Pro card used PowerCinema 3 to successfully capture TV. With the 9800 card installed I get most of the functionality but when I press the TV button on the remote then I am taken through the Channel Detection Wizard. However, when I select 'Antenna' and 'Fast Search' there are no entries in the list for Step 1 and the Autoscan for Step 2 is disabled. I tried running the card with PowerCinema and I can receive channels. Any help would be gratefully appreciated. Regards 
|
|
#2
October 30th 05, 12:53 AM
|
|||
|
|||
|
AIW 9800 Channel Detection Wizard Problem
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dell's Sorry History of Microphone/Soundcard Issue | Ted Zieglar | Dell Computers | 16 | October 31st 05 03:09 AM |
| 9800 Pro feezes during 3D games | Fish | Ati Videocards | 26 | February 17th 05 03:31 PM |
| This problem has baffled everyone... | Nick G | General | 46 | May 22nd 04 04:01 AM |
| This problem has baffled everyone... | Nick G | General Hardware | 43 | May 22nd 04 04:01 AM |
| IDE Channel problem | Magic Blue | General | 2 | February 24th 04 08:25 PM |
Linear Mode
