If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Thanks.
"Kilgore Trout Jr" wrote in message .net... You've probably already seen this and I don't see any specific memory timings either except for the CL3. http://www.valueram.com/datasheets/K...64C3AK2_1G.pdf This is described as a "value" product and the CL3 confirms that this is not high performance memory so you might be best served by going with the SPD settings. I would bump the DDR voltage up by at least 0.1 v as this product is rated at 2.6 v +/- 0.1 "mark7dc" wrote in message news:tf%lb.72616$La.33995@fed1read02... The data sheet for my Kingston doesn't show the memory timing values. Any ideas where I might find those so I can set them? I have KVR400X64C3Ak2/ 1 G TIA |
#12
|
|||
|
|||
I'm using it, and I have a little problem, the motherboard doesn't
find my sata maxtor diamondmax plus 9ds harddisck. I've tried everything I can think of, all of the sata entrance, configuring the hole BIOS, updating it, it was same as already had, changing boot sequence, making the sata drive start as pri. master HDD, and all the other thinks I could think of but noting works. Could someone please help me "Alan Guest" wrote in message ... Is anyone using revision 2.0 yet? Alan |
#13
|
|||
|
|||
I'll try. Where do you have the Maxtor SATA connected to your
motherboard? Are you going to run the Maxtor SATA along with another hard drive on the IDE Primary cable or as the only drive on your PC? "Pieter" wrote in message om... I'm using it, and I have a little problem, the motherboard doesn't find my sata maxtor diamondmax plus 9ds harddisck. I've tried everything I can think of, all of the sata entrance, configuring the hole BIOS, updating it, it was same as already had, changing boot sequence, making the sata drive start as pri. master HDD, and all the other thinks I could think of but noting works. Could someone please help me "Alan Guest" wrote in message ... Is anyone using revision 2.0 yet? Alan |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Asus A7N8X-X and AMD Athlon XP 3200+ | Information Scavenger | Asus Motherboards | 30 | November 9th 04 09:30 PM |
Update on Athlon 2600 Ghz discrepancy | David Simmons | Overclocking AMD Processors | 7 | August 27th 04 08:56 PM |
Update on Athlon 2600 XP problem | David Simmons | Asus Motherboards | 3 | August 27th 04 03:52 AM |
8KNXP slow copying over LAN | Scott | Gigabyte Motherboards | 3 | September 2nd 03 10:54 PM |
Plextor Premium firware revision | Richard Dower | Cdr | 5 | July 18th 03 05:49 PM |