A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Motherboards » Abit Motherboards
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

nf7 dual channel memory question?



 
 
Thread Tools Display Modes
  #1  
Old September 14th 04, 12:48 PM
Christo
external usenet poster
 
Posts: n/a
Default nf7 dual channel memory question?

I have 3 modules of memory on my NF7 v2.0 board. 2 of these are PC2100 266
mhz 512 mb modules.

I have these in the two slots closest together.

In the second channel i have a PC2700 333mhz 512 mb module. When i boot the
memory displays as frequency 266 mhz... however there is 1.5gb of memory
being Ok'd

my question(s) are/is would i be able to host a 266 mhz PC2100 module and a
333 mhz PC2700 module on the channel with 2 slots?

Also seen as the primary channel as it would appear (the channel with two
slots on it) is checking the ram and noting it as 266 mhz does this mean the
second channel will only run at 266 mhz?

and finally why has the system decided to say "yep its 266 mhz" when i also
have a 333mhz module also.... is it because there are more 266mhz modules
than 333 mhz modules or because i have the 266 mhz modules in the primary
channel?

this raises one final question... if it is due to the fact that both modules
are in the primary memory channel then what would be the outcome if i had
say a 400 mhz module and a 266 mhz module in both the slots on the primary
memory channel?

woaaahhh

what a load eh!


 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
fsb speed - why does it matter? James Hanley Overclocking 52 November 7th 04 01:04 PM
dual channel memory question sam unwise Homebuilt PC's 4 April 23rd 04 07:50 AM
A7N8X Deluxe and "dual channel" question??? Irrat8ed Overclocking AMD Processors 10 April 3rd 04 10:27 AM
How to tell if running in dual channel mode? Destroy Overclocking 10 March 9th 04 02:13 AM
Dual channel memory (cas3.0) VS. fast (cas2.0) memory badr Overclocking AMD Processors 8 February 11th 04 09:33 AM


All times are GMT +1. The time now is 05:53 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.