If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Follow Up - Way to restore the grip on pinch wheels
Thank you all for the advice given. Got the CaiKleen rubber restorer
recommended by GR in the mail today. I even followed the directions. Results? Perfect!!! Printing heaveyweight glossy all afternoon. 30 plus prints. No slippage or jamming at all. Thanks again to you all for the advice. |
#2
|
|||
|
|||
Follow Up - Way to restore the grip on pinch wheels
William Holohan wrote:
Thank you all for the advice given. Got the CaiKleen rubber restorer recommended by GR in the mail today. I even followed the directions. Results? Perfect!!! Printing heaveyweight glossy all afternoon. 30 plus prints. No slippage or jamming at all. Thanks again to you all for the advice. And thank you for the solution post. |
#3
|
|||
|
|||
Follow Up - Way to restore the grip on pinch wheels
Just for interest sake, does this mention what it's main ingredients
are? Does it have a strong smell? Art William Holohan wrote: Thank you all for the advice given. Got the CaiKleen rubber restorer recommended by GR in the mail today. I even followed the directions. Results? Perfect!!! Printing heaveyweight glossy all afternoon. 30 plus prints. No slippage or jamming at all. Thanks again to you all for the advice. |
#4
|
|||
|
|||
Follow Up - Way to restore the grip on pinch wheels
On Sat, 18 Feb 2006 19:32:10 -0500, William Holohan
wrote: Arthur, Says: Contains, petroleum naptha, terpene hydrocarbon, chlorinated parafin. It has a strong orange oil odor. Solution appears to be mostly volatile. Evaporates from glass surface leaving very light oily coating behind. I would assume that what is left behind on glass would be absorbed into rubber. Bill "Irish" Holohan |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Way to restore the "Grip' on HP1220c grip (paper advance) wheels??? | William Holohan | Printers | 9 | February 15th 06 12:32 PM |
restore problems and ?'s | [email protected] | Packard Bell Computers | 9 | November 17th 05 12:59 AM |
What do you use for backup today? | Mxsmanic | Homebuilt PC's | 46 | July 18th 05 09:19 PM |
Software to backup the operating system on drive C | Brian | Storage (alternative) | 18 | October 22nd 04 01:24 AM |
Need help: System Restore malfunction | HistoryFan | Dell Computers | 18 | February 6th 04 10:04 PM |