If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
My AQXEA Barton 2500+ @ 2.2GHz (NF7-S v2.0)
Hi all,
I just got to the stage where I am 100% satisfied that my system is working great at stock settings. I have tested the memory timings, and I have tested my FSB above 200MHz. Now I am working on overclocking my cpu. When I first switched up to 11 x 200MHz from default 2500+ all I did to test the overclock was run MemTest x86 from the boot floppy. Of course to really test the CPU overclock I needed to run tests from WinXP itself, but I was a little anxious about causing my boot-drive to become garbled from a dodgy CPU overclock (it's happened to me before). Anyhow even though it was working fine in MemTest x86 @ default Voltages, once I got into WinXP (phew it booted fine) and ran Prime96 torture test, it would fail within a minute. . .pooh! So it was time to up the Vco 1.65v @ 2.2GHz - Fail Prime95 1.675v @ 2.2GHz - Fail Prime95 1.7v @ 2.2GHz - Fail Prime95 1.725v @ 2.2GHz - Fail Prime95 1.75v @ 2.2GHz - Been running Prime95 for 10 hours so far! Temps are up up course, hitting 46c Load so far, I had to crank up my CoolerMaster Aero 7 LITE Fan to 100% to keep the temps down a few degrees. I will leave prime95 running for a day (or two), then when I am happy it is Rock-Solid I will tinker with a higher FSB to add to the CPU overclock (thinking 10.5 x 216MHz-FSB). Is 1.75v ok to be running this chip at, as I said temps are ok so far. . .I hope it passes the Prime95 test as I don't really wanna raise Vcore above 1.75 if I can. . . Wayne ][ P.S I have CPU interface enabled. Is there some options that make a CPU overclock less stable? (spread-spectrum etc) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Worth getting Barton 2500 now that Athlon64 is here? | Steve Wolfe | General | 22 | August 23rd 04 11:30 PM |
Is this mobile Barton 2500 a good overclocker ? | Phil Weldon | Overclocking | 0 | June 21st 04 05:08 AM |
Overclocked 2500 Barton to 3200 using my old Crucial 2100 DDR | [email protected] | General | 5 | January 18th 04 09:01 AM |
Will a 2500 Barton run and OC on a Turbo 2 v5, if so how? | KG | Overclocking AMD Processors | 9 | September 3rd 03 02:05 AM |
PC2100 DDR Ram with Athlon XP 2500 Barton? | Mr. Brian Allen | Overclocking AMD Processors | 2 | July 21st 03 09:13 PM |