If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Com1 / IRQ4
"kony" wrote in message
... On Sun, 22 Jun 2003 16:09:58 -0400, "alvin york" wrote: "Matthew Del Buono" wrote in message ... Com2 is usually used for modem. Internal modem requires disabling COM2 in BIOS. Hey my modem uses COM3 and it works fine. And I thought IRQ7 was the mouse? I always thought IRQ7 was for LPT1, usually the Printer. It is IRQ7, but an internal modem doesn't "normally" require disabling the motherboard's COMM port.. doing so should work too, but an ISA or PCI hardware or winmodem is supposed to work fine on another comm port, and more often than not, they do use some other comm port, since almost all motherboards default to having the onboard comm port enabled. Dave Dave you are probably correct, BUT I WANT my PC's to use COM2 for my internal WinModems so I "disable" COM2 in the BIOS . It works for me. To each his/her own preference is my motto. whatever suits you. |
Thread Tools | |
Display Modes | |
|
|