If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Professional Workstation 5100
Hi,
i have an old Compaq Professional WS 5100 dual PII-300 with no bios and without f10 partition. The problems it's related to the setup's diskettes: "F10 Setup and Diagnostics for Compaq Workstations / version 1.15 A (8 Oct 98)". When i try to run setup.exe, after booting from the diskettes, the program tells me there is no or it's the wrong version of a driver called cpqcm.sys. But i have this driver and load it in the first line of the config.sys. I've tried with two versions of this driver, 1 and 2. In the process of booting i can see that the driver boots good and it detects a ess1868 sound card (on motherboard). So i don't understand where it's the problem. In fact the soft paq that you download have no cpqcm.sys driver in it, so why it needs it? I know cpqcm means compaq configuration manager, and it's possible that this driver be necessary to detect any isa-eisa plug n play card. The question it's: there is another version of cpqcm.sys which functions? Thanks, Jose Lucas |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SP700 Professional Workstation | Michel Beaussart | Compaq Computers | 1 | December 12th 03 02:22 AM |
Professional WS 5100 or AP500? | Jose Lucas | Compaq Computers | 0 | November 19th 03 12:32 PM |
Professional Workstation 5100 | Jose Lucas | Compaq Computers | 0 | November 19th 03 02:29 AM |
clear CMOS/ reset BIOS on Professional Workstation 5100 | Richard | Compaq Computers | 1 | October 14th 03 09:29 AM |
Professional Workstation at W8000 | CHANGE USERNAME TO westes | Compaq Computers | 0 | October 13th 03 05:04 PM |