If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
ga7zx wierd problem after upgrading to winxp
i just upgraded my win98se to winxp...however when i completely shut down
then restart, my keboard has an exclamation next to it...i can uninstall, then restart and i have keboard functionality. Only after i complete shutdown and restart do i get the yellow exclamation point for the keyboard. also, i have a new case for this board that comes with 2 usb ports upfront. where on the board can i install these 2 usbs? any suggestions... the reason being the keyboard works with usb, but i only have 2 usb ports that i am using already.. thanks |
#2
|
|||
|
|||
For the usb's on the front of your case look on your motherboard book to see
where they are, then connect the cables from your case, to your motherboard, noting the correct orientation of the wiring, by that I mean check the pin arrangement is as the motherboard is. On my board GA 7N400PRO there is 5 pins above with 4 below, the cables on my case were both 4 pin connecters with 2 xtra earthing connections , pin 4 on the both of them(the motherboard and case) is the earth, hope I haven't confused you to much :-) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem upgrading HDD | Jeff | General | 9 | August 20th 05 09:37 PM |
Problem in Upgrading | philo | General | 3 | January 17th 04 04:20 AM |
Problem upgrading Abit BX6 rev 2 CPU | Mike | General | 3 | August 15th 03 10:18 AM |
Problem with built-in sound when upgrading | Jon Greene | General | 4 | July 10th 03 10:41 PM |