If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
AMD Calculator v1.0.0.1
I set my K8 Winnie 3200+ to 8x in the bios and clocked at 240. On bootup
CrystalCPUID grabs it and varies it between 5x, 7x, and 10x. If I lock it at 10x using Crystal, then start the AMD Calculator, it thinks it's at 8x. It is apparently reading the bios setting, not the actual multiplier. BTW I boot at 8x because I let Crystal vary the voltage with speed, so I have to have the voltage on auto in the bios, and if I booted overclocked the cpu wouldn't have enough voltage to not make mistakes until Crystal grabbed it. Crystal can only overvolt it a little to 1.45, but it's enough for 240, where the value ram comes up from 166 to 200. -- Ed Light Smiley :-/ MS Smiley :-\ Send spam to the FTC at Thanks, robots. Bring the Troops Home: http://bringthemhomenow.org Fight Spam: http://bluesecurity.com |
Thread Tools | |
Display Modes | |
|
|