If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
IOPS from RAID units
Cydrome Leader wrote:
Bill Todd wrote: Cydrome Leader wrote: .... I noticed you cut out my question, probably on purpose. Indeed: I ignored it because it demonstrated the profoundness of your ignorance. As I suggested, when it comes to disk arrays (and to the way disks are themselves accessed, for that matter - at least in the two decades since the ST506 interleaved interface was superseded by contiguous multi-sector transfers), you obviously require some very basic tutoring - well below the level of discussion that this group is aimed at (and that I have any interest in pursuing). - bill |
#12
|
|||
|
|||
IOPS from RAID units
|
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
IOPS calculation for SAN Design | [email protected] | Storage & Hardrives | 4 | October 21st 07 02:41 PM |
IOPS from RAID units | [email protected] | Storage & Hardrives | 8 | July 21st 07 04:20 PM |
nfs ops to iops formula? | Faeandar | Storage & Hardrives | 7 | February 23rd 06 04:18 AM |
Base Units | Gordon | UK Computer Vendors | 3 | October 20th 04 11:12 PM |
FS: UV Exposure Units. | [email protected] | Homebuilt PC's | 1 | December 7th 03 12:29 AM |